Kenmore elite oasis dryer model #110.6708

Another possible reason why your Kenmore Elite Oasis dryer model 110.67042600 won't start is because the door switch is defective. The door switch is located on the door of the dryer. To check the door switch:
1. Unplug the dryer from the wall outlet.
2. Open the door of the dryer.
3. Locate the door switch on the door of the dryer.
4. Use a multimeter to test the door switch for continuity.
If the door switch is defective, it will need to be replaced.

Check these instructions out.
http://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dryer/1-6-917283-/Kenmore-Dryer-won-t-start-11067032601

The thermal fuse is located in the vent duct.

check door switch, the push start button and the thermal shut off fuse

THINK THATS A THERMAL FUSE

Check the thermal fuse for continuity.

Press and hold the "Start" button to restart the dryer cycle if the "PF" (power failure) error code appears. This code often appears when a cycle is interrupted before it completes. You may also check the breaker or household fuse, and ensure the machine has not come unplugged.


Read more: How to Repair Kenmore Elite Oasis Dryer Error Codes ' eHow.com http://www.ehow.com/how_7703883_repair-oasis-dryer-error-codes.html#ixzz1u

Check the thermal fuse. You can temporarily bypass it by hooking its two wires together then see if it heats.

about $10.00 for the thermal fuse and 1 Hr Labor (my rate is $30.00 per hour) and a service call,rate depending on where you live

F40 = thermal fuse blown.
If the fuse is OK the error points to a communication problem between the machine control board and motor control board (check connectors).

Remove the lower front cover - it has spring-loaded keepers that can be gently pryed and the panel should either hinge down or pop off. The thermal fuse and ignitor are behind this panel.