Error Message: Condition 1

Fujitsu Plasmavision with error Message Condition 1

www.experthelp.com > question > fujitsu-plasmavision-...

Jan 1, 2014 - The "Condition 1" error message indicates that the fan inside your TV is defective. This will prevent the TV from powering on in case it overheats ...

Error condition 1 is a faulty Fan. On these units if one fan is faulty then the sensor will shut the screen down as a protection.

hi. Conditios 1 or 2?

Hi,

Condition 1 error denotes there is some defect in the fan inside.

You cannot deal with this problem.
Please remove the plug from receptacle and contact you dealer

Thanx

Hi,

When you get the Error message conditon 2 ,It denotes that the internal components are HOT.

Please remove the power cord from the receptacle and allow it to cool sufficeintly.

After cooling sufficiently power it ON,If you get the Error message again then remove the power cord and contact your dealer.

Thanx

Hi Mark,

You have a faulty fan or fans which is causing the screen to switch off as a precaution. A repair can be carried by fujitsu.

Regards

See Fixya tips and tricks:-
'Fujitsu Plasma 42" random shutdown - continuous flashing red'

While the model of your set is slightly different, the checks described generally still apply, as it is very similar.

Hello,

Does the scanner displays any error message on the scanner panel? Is there any TWAIN error message?

If paper jam occurs, U1 error will be displayed on the scanner panel and TWAIN driver will display " Paper jam the ADF (Code DS32002)" error message.

This error is detected when one of the followings occurs:

1) A document does not reach the TOP sensor while the scanner has transported the document about 250 mm to pick. (The scanner
performs retry operation.)

2) The trailing edge of a document does not reach the TOP sensor after the scanner transports the document by the length (L) below. (The document may have slipped on the rollers) Scan condition Transported length.

In order to assist you with your scanner issue, Please provide the issue details with error message.

If nothing is being displayed, then the issue could be due to failure in Pick Motor function or Pick Sensor malfunction.

Hope the above information is helpful.

Thank you for contacting FixYa.

Regards,

TechSatya

From service manual -
Error message condition one = fan protector operated.
Check:-
Fan,
Main Power pcb,
Main digital pcb.

My plasma display the "error message condition 1" and red flashing light start blinking and TV screen shut down. Who can halp me to fix the problem??