Where can I get a drive motor for my Weslo Cadence

On the rear of walking deck you have the left and right feet. Down the deck is at 0 degree incline, fold them up and you have a 3 degree incline.. You have no incline motor on this model.

RUN the software calibration for diagnose, troubleshooting , fix it.
adjust the speed sensor, clean it and tight the wires connector
LUBE the deck belt+rollers bearing too
SEE THE diagram.

God bless you

take a look at the motor belt i bet its worn thus it cant turn the front roller rite.

hi if you can take off the front pannel where the motor is. its look like the belt on the motor a either slipped off or you need a replacement,

FitnessRepairParts may be able to sell you a manual if you can't find it anywhere, depending on which version of the 825 you have (there are quite a few.. check for other model numbers on your machine
http://www.fitnessrepairparts.com/part_search/EquipmentSearch/weslo%20cadence%20825

You can also try IconService.com and click on "Manuals" - sometimes they have manuals you can download or purchase.

The only lube required is between the walking belt and the deck. You can get the lube from iconfitness.com. Lift the walking belt and squirt some on the deck from each side, underneath the belt in the area where you usually walk. Walk on it for a few minutes to spread the lube around.

I centered the belt on my tredmill and now it wont move at all. I tighted and loosened the belt. motor runs belt wont move

go to iconservice.com they have free manuals and also you may purchase replacement parts there as well. Be sure to get your model number before going to the site to make it easier (lower frame of the machine)
Good luck, Tim

Hi Jill, have you found a solution yet as I seem to be getting a sililar error. Do you get a E02 message and a beep. Thanks Nicky

Hi, I don't have a manual on your particular treadmill but most all treadmills use the same type of belt tension and tracking, which is an allen screw adjustment on the rear tension bar. One on either side. You should have been provided an allen wrench with your treadmill, if not then use one of your own the proper size. Make the adjustment with the unit running at its slowest speed. Clockwise tightens the tension and will draw the belt. Good Luck, this should Fixya!