I am attempting to print multiple copies of a document but my Aculaser c900 only prints the first page and then stops with the red light flashing. I have checked for paper jam and it not that. I have Windows 7 and I no longer see the status of the consumables but they should be OK. Any advice? Thanks
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check the status monitor and see what further error message ... for this model, it's very prone to mech problem at the feeding area, you will need some tech know how to remove and repair.
I have a similar problem with an old HP LJ1300. They have not updated the driver correctly and don't intend to fix it. I can't find any reference to AcuLaser C900 on Epson's support page. So maybe they stopped supporting the C900.
check the toner ,, check paper jam and ,, paper tray ,, or any sensor issue,, don't give the print order untill you see the green signal over the printer...
The printer probably went offline, as far as your PC is concerned. On your PC, in the properties for that printer, click File and UNCHECK "Work Offline"
Sounds like one of your cartridges has been damaged. I had this after I had re-set one. Take them out and check the rollers for scratch marks. Then replace the damaged cartridge.
Try cleaning your ink nozzles or ink jets. It sounds like you have a plugged nozzle or two. Your printer program should have maintenance options that allow you to test for plugged nozzles and clean them.
In control panel, open the printing/fax icon, right click on your printers icon, left click properties, then on the bottom of the page the panel that opens you will see a button that says printing preferences, and that should open your print program.
I did much the same and am looking to see if there is a solution here! Tried cleaning the glass filter, which pulls out about 250mm and is located just below the transfer unit - small grey tab, behind waste collector. It helped, but still a slight white band on the print.
×