My sony bravia model nos.klv-26S400A IN5 its lcd

The problem is the LCD panel. It could not be repaired, it called a pixel retaining problem.

Hi. This is a fault code and should be similar to the Sony in this guy's video.

HTH

https://youtu.be/0KGysXbxnaU

I have same problem with klv-32t550a i thinkk this is a error of display card

That sounds like a defective LCD panel tab, Sony's and Samsungs are notorious for this problem. Does the problem go away when the set warms up or when you tap the screen?

Here is a link to the service manual--

http://www.scribd.com/doc/46056922/KLV-23S200A-and-Other

Page 11 explains the error codes--unless you are a tech with a meter etc it will be a shop repair.

A lot of good info including taking set apart correctly.

"abnormal power"

SD TECH

You have a faulty power supply which needs to be repaired by a TV repair shop.

I had a similar problem with my Phillips 42 in. LCD HD TV.

Here's the problem. The Power Supply Board. I opened my TV up(warranty was up of course) and found several bad capacitors. Phillips and several other companies were sold capacitors that although were highly rated failed within 5 years because of a lack of preservatives. All sorts of electronic equipment is now being effected due to these defective capacitors.
Solutions?
1. Take it in and have it fixed
2. Open it up, check the board for faulty capacitors(bulged or leaking) Buy a new Power supply board and install it.
3. Remove PSB, remove faulty capacitors and replace with compatible new ones.
Capacitors are very inexpensive. Less than a dollar a piece.

Hope this helps

Hi,the problem is from the fuse in the tv,it's blown and it's a means of in-built security against power fluctuations from damaging the unit,so the solution is to replace the fuse of the TV to restore your unit back to a normal working condition.

Be cool.

Usually the LCD panel cost is around 80% of total TV price. Look for it in a center of service.

8 blinks in KLV-32S400A shows Audio Error
Check audio voltage supply from power supply board, if OK, replace GP Board (main board)
and if audio volts are not available, check/ replace power supply board.