Toshiba rear projection screen

Look on Ebay under TV Parts and try Encompass Parts
1-800-638-3328

Call Encompass Parts they mighty have one in stock 1-800-638-3328 also call TV shops ask for Used one in New condition sometimes you can get them for $100.00

have checked the net and you can get front screen replaced on any size projection tv try
email [email protected]

you have two screens. a fresnel and a lenticular lens. they are expensive but easy to install

Most likely the lamp is dying. Try replacing the lamp before calling a repair tech. What does the Owners manual say about the blink lights?

If you have to replace the linticular screen the cost will be prohibitive. The outer Plexiglas can be purchased at a hardware store although it will not have the glare reduction as most of the big screens have but it will work. Your best bet is to contact a tv repair shop and ask them if they have any toshiba 50" sets they are parting out and ask them for the cost of the screen. That may be your most cost effective way. I know if we had a customer to ask we would sell them one at a resonable price, but unfortuinatly our shop does not have any toshiba sets junked out. We have several sony's though.

get new ic's and replace them the kit is like $30 if you are good at soldering

There is one mirror inside. It is easy to remove the front plastic screen by removing the bottom fabric grill (snaps off by pulling outward like a removable speaker grill). Remove several wood screws along bottom edge of screen. Lift up the whole plastic screen frame and pull it away from the TV; but be careful with the control wires that go to the center panel, which snaps off the big screen frame easily. The mirror is right there.

are you talking about the plexiglass glare screen?...or something else?...
i was trying to find this out in your previous post about this set...

1) Remove lower,front speaker grill
2) Remove screws along bottom edge of screen frame
3) Lift screen assembly off cabinet
4) Lay assembly face down
5) Remove just enough frame screws to get back in position--
    Don't force it----
6) Reassemble.........T.