The joystick is not sensitive enough, there is a pause between the joystick movement and the motor response. Jazzy 1120 how to adjust it?

You don't you, replace joystick. However, should you take the joystick apart you may have many hours of intense frustration awaiting you.

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

PDF]INFINFB2043_Jazzy_600-600XL_Troubleshooting_Rev B ...

www.pridemobility.com/download.php?...Jazzy_600-600...

Pride MobilityWhat if the systems on my Jazzy 600/Jazzy 600XL seem to be "dead" (controller does not ... Each controller will flash a code via the battery ... 7. Joystick error. Contact your authorized Pride Provider. Four yellow LEDs ... This is indicated by the VR2/VSI speed ... flash in a numbered sequence followed by a 2-second pause

Hi Judy,

According to Pride's troubleshooting documents the service indicator (wrench icon) will flash when a fault is detected by the dynamic controller.

The number of flashes, followed by a 2 second pause, indicates the issue. You will need to count the flashes to determine the cause and a possible solution.

I have typed the flash codes below, but you can also see them on a larger table here: http://www.fixya.com/support/p3641679-pride_jazzy_614_hd_jazzy_614hd/usermanual-6B42026-pdf

FLASH CODES
Code #1

• Flash Code: One, pause, one
  
• Cause: Possible Stall Timeout
  
• Possible Solution: Turn joystick off, then on.
  

Code #2

• Flash Code: Two, pause, two
  
• Cause: Battery Fault
  
• Possible Solution: Charge batteries, check battery connections and fuses.
  

Code #3

• Flash Code:Three, pause, three
  
• Cause: Left Motor Fault
  
• Possible Solution: Make sure the left motor is plugged in.
  

Code #4

• Flash Code: Four, pause, four
  
• Cause: Right Motor Fault
  
• Possible Solution: Make sure the right motor is plugged in.
  

Code #5

• Flash Code: Five, pause, five
  
• Cause: Left Park Brake Fault
  
• Possible Solution: Make sure the left brake is not in freewheel mode.
  

Code #6

• Flash Code: Six, pause, six
  
• Cause: Right Park Brake Fault
  
• Possible Solution: Make sure the right brake is not in freewheel mode.
  

Code #7

• Flash Code: Seven, pause, seven
  
• Cause: Joystick Fault
  
• Possible Solution: Check the joystick connection.
  

Code #8

• Flash Code: Eight, pause, eight
  
• Cause: Power Module Fault
  
• Possible Solution: Check connections to the power module and batteries.
  

Code #9

• Flash Code: Nine, pause, nine 9
  
• Cause: Controller Communication Fault
  
• Possible Solution: Check bus connections from the joystick to the power module.
  

Code #10

• Flash Code: Ten, pause, ten
  
• Cause: Controller Fault
  
• Possible Solution: Contact Technical Service for assistance.
  

Code #11

• Flash Code: Eleven, pause, eleven
  
• Cause: Incompatible Device Fault
  
• Possible Solution: Contact Technical Service for assistance.
  

"Cuts out" is not enough info. Check all connections for tightness, full battery and light codes.

sounds like the motor brushes need replacing.

If medicare paid for Dad's chair then contact Roadrunner Mobility @ 1-800-467-2668 or Repair Xpress @ 1-877-581-3733. If Medicare didn't pay for Dad's chair then the cost of a refurbed joystick is still very high about $700 and if the joystick got wet then he'll need a new or refurbed one. Sorry Hope this helps

Good evening.Download this Adobe Acrobat Document:- troubleshooting_2007 SHOPRIDER.pdf
In there you will be delighted what you find,its 36 pages long.Pages 1 to 5 batteries and chargers 6 to 18 on scooters & 19 to 36 on wheelchairs.Any problems ask again.Have a nice day.Colin.

GAdams You need to count the number of flashes. The number of flashes will give you the flash code or error code. IE: 3 flashes pause 3 flashes pause etc. = left motor short If you have your owners manual it should list the flash codes and what they mean for your chair. If not you can contact Pride Mobility @ 1-800-800-8586 and ask for Tech Support. If medicare paid for your chair the they will pay most of the repair cost. Contact the provider where you got your chair to see if they can repair it or refer you to a service Company that can. Hope this helps

1. make sure it's not still pluged in recharging.
2. make sure both free wheel levers are engaged.

if the jazzy is still flashing and not moving refer to the flash code in your owners manual. count the flashes between pauses. get back to me if you don't have the manual. Mike
[email protected]

Im guessing you can adjust the sensitivity in the game, or adjusting the sensitivity on the joystick directly.