Since the new dryer was installed our home water

You can check out the installation manual here that has a parts breakdown: https://s1.img-b.com/build.com/mediabase/specifications/franke/512399/ffps200_installsheet.pdf
Be sure to shut off the water below the sink prior to doing any disassembly.

Best of luck

If you've noticed the water pressure in your home is either too high or too low, you may need to adjust your water pressure regulator. Water pressure is measured in "psi" (pounds per square inch) and should be set between 50-60psi for home use. Anything greater than 60psi can damage residential water lines and appliances. Not all homes have a water pressure regulator installed, but if you have one and can locate it, all you need is a few tools to begin adjusting your best pressure washer

check pressure in pressure tank. should be same as water pressure. low pressure in pressure tank will cause issues.

Your oil pressure should be between 10 and 20 psi. And if it is low or you don't have Amy oil pressure change the pump. But no you don't need a new engine if you fix the problem in time

In all of the newer faucets there are flow restrictors to reduce water consumption.

You are getting too much water to your icemaker, either faulty water valve or extremely high pressure or extremely low pressure either way will cause too much water in your icemaker, extreme low causes water valve not to shut off, high pressure lets too much water through when it opens. These pressures are not adjustable in the fridge. You can on certain models adjust the amount of time the valve is on, per the icemaker, it usually will have a screw on the side of it towards the front of the icemaker.


Sean

Mine only smell mildewy if I leave them in more than an hour before drying. My old top load washer did the same thing. I dont wash unless I can immediately switch to the dryer.

First check the pressure into the frig. Sometimes the inlet line can get kinked. The second thing I would buy is a NEW water valve. There only about $20-$30, and not too hard to install. A nut driver and a pair of plyers should be the only tools needed. There are usually 2 water valves, one for the water, and the other for the ice maker. If 1 is bad... the other is next to fail soon, so buy both before to save head aches down the road.

Yes it is very common more so on hot side, the water stops or shutoffs can become plugged with hard water deposits and calcium build up. Shut off main water, unscrew supply lines from shut offs under sink to see if this is indeed the problem.

The only other problem that will allow the water to freeze would be a lack of water pressure. You can try to unhook the water line and turn the water on and run it into a sink or large bowl. You will be able to see if you have good water pressure. If the pressure is good, check your water filter. If the water pressure is low, you may need to call a plumber, or you can install a new water line. Good luck and sorry for the delay in the reply. I hope I was able to fixya. Mike