Problem for lipi 6312 tally genicom line printer my printer shows an error (hammer voltage 1)

In Lipi 6306 line printer "Checksum fault block 8".It is not going on offline.What should I do now.I have not faced this type of problem before. os window xp

Replace the print head

There is most likely a fault with one of the hammer coils, this would need investigating, other possible causes;Faulty / damaged ribbon cableFaulty main boardUpdate firmware, the error should change to a more meaningful error with later firmware

A high resistance coil fault has likely occurred in one or more of the hammer coils.
Note: this fault message will have been preceded by printing slow-down attempts associated with On-
The-Fly thermal monitoring of hammer bank temperature.
Check the hammer bank for defective coils.
If no defective coils are found replace the Controller Board.

Dear Sir,

Problem in paper calibration, u can go through given details 1) Offline, Test, Daig, Calib, Paper out, Enter, then u see Remove paper. then press enter. sum reading will come (4.something). After insert paper, (2.something). And Save == Offline enter, config enter, configuration enter, save enter, Power up. enter.

Next option 2) U can check the paper out sensor front one black sticker missing.

Parashuram Patil

1. what is the main reason for hammer voltage

The problem coming from your logic card hammer bank cable . Need to be replace logic card and hammer bank cable.

This error indicates that there is most likely an issue with the Hammer Driver's you may need to replace the logic board.
I would however try upgrading the firmware to the latest version, I think this is version 4.0 as I believe this may contain some fixes for Hammer Voltage errors.

ERROR IS BECAUSE OF DRIVER IC FAULTY IN LOGIC CARD
PLZ CHANGE THE HAMMER DRIVER IC IN LOGIC CARD

the problem comming from logic board. need to change the logic board and hammer bank cable at the same time.