Power went out in house, now my dvd player won't do anything.

the roller have problem, fix it with oil

i need the model number.

Sounds like the power supply in the dvd player has failed. It works just well enough to turn on the led infront but as soon as you go to do anything it shuts off. This is common in cheaper dvd players. Unless you can troubleshoot electronics. Or know someone that can. Your best bet is to unplug the unit and disassemly and retrieve your dvd.

The power supply regulator boad should be checked for fault. Even though the fuse is OK, there might have damaged component/s on it.

From the description you have provided, the microprocessor controller ic is failing which is the brains for the whole system. I suggest repacing the complete unit rather than have it repaired because it would not be cost effective.

Since this question is almost 4 years old the quick answer is to buy a new dvd player. They are very cheap now. Good Luck.

Unplug it for a week or so. then plug it back in and it will reset. It must take awhile to discharge the capacitors in the machine to reboot the thing if you get a voltage spike or anything. Ours did that too once when the electricity went out suddenly. Then it wouldn't turn on.

I took it over to my house and left it set for a week and tried it again and it worked fine. So I took it back to my mothers house and used it. It's still working three years later.

My expensive JVC did the same thing to me.

Sound like to me you got a problem with the capcitor inside the unit, if its under warrenty it will need to be serviced. If its not I ould be checking capcitors inside to make sure there not bulging leaking or otherwisen ot wroking correctly.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Charger does't connect to DVD player.

Connects to battery. Built your own, Radio Shack, female to male jack, power supply from anything handy or spend $2 at thrift shop, $2 multimeter (Harbor Freight, Cheapo), junk variable resistor (pot).

7.4--8 V adjust. Or, get fixed value resistor dependent on PS voltage.

Charge anything,

And power supply for DVD house current.

[email protected]

I don't see any opening hole to retrive the CD inside the best option we can do is to open the the cover chasis and pull out the cd on the tray.

Thanks,