Kenmore Stackable washer/dryer Model #11088752793, won't heat

Yes, but you normally have to remove the case. In the case of a stackable unit, sometimes you can get in from the back panel.

https://www.google.com/search?q=kenmore+stackable+washer%2Fdryer+417.94702300+replace+water+level+sensor

..

This is an excellent source. Click on the link

http://www.repairclinic.com/Shop-For-Parts/a17b6d632276-x6d6f64656c/Model-Model-41798702891-Kenmore-Washer-Dryer-Combo-Parts

You have a broken belt.

Possible that the heating element has burnt out, or that the thermostat that controls the element is defective. If you have a low or warm setting try that also as it may use a different element? Good luck.

Could you please post the model number of the unit? It will be under the washer lid, in the dryer door, on the top, or the side of your unit.

You will need to get 230v to allow the dryer to work if your service panel has 230 you will need to get a 30 amp two pole breaker and run 3 wire #8 in size. Then get the socket and plug for the dryer. The 110 in the model number simply means made by whirlpool and is a pretty good machine but requires 230 volts to dry with heat.

there should be a small fuse on the heater box,if that is not working the element will not work also-mike

hi thanks for the question just underneath the dryer on the front theres a panel remove this panel the element is on the right thanks for the question the appliance doc

the washer works off the 220v cord on the back you have other issues with the washer sorry

Dryer probably element or thermostat, washer sounds like a suspension arm collapsed. Price up the parts & then decide if its worth it! Regards