THE BLACK PLASTIC HUB THAT HOLDS THE CD INSIDE THE CAMERA IS BROKEN. UNABLE TO LOCATE REPLACEMENT PART.

http://www.repairclinic.com/

https://www.fixmyblinds.com/blind-categories.html?gclid=CjwKCAiAnsnjBRB6EiwATkM1XnW3Vz9TgFeFPTapEDaVSzOvXjosxGQ-DgRFLOnpY4jtCLOUiKIf3RoCCTMQAvD_BwE

Check this site

dealer or scrap yard not usually an after market part try ebay

try some black duck tape that might help until you can find a replacement parts

If you visit Sanyo service center, then they will provide you that parts. Thanks.

If only the viewfinder glass is broken, you can put other one to replace it.

It could be glass but I do recommend you to replaced with an acrilic or a plastic part.

You can get it from different soruces: Ebay from a broken camera (S2, S3 or S5), or use transparent plastic film and cut it to the right size.

You don't need to open the camera completely. You will need just to remove the viewfinder rubber protector, and carefully, pull the viewfinder frame that holds the glass. There are four plastic locking tabs (two up, two down).

Best regards,

is that the automatic hub ? ... if so leave your email address i'll send you the diagram for it.

Replacement latch can be found at amazon, click here Amazon com mailbox latch and chose needed one. Wish you best of luck. John

If you need a replacement turntable coupler, you can find this part listed as item number 942560 at repairclinic.com. Just type in your model number.

To replace, all you need to do is carefully slide something under the existing coupler (if you can) and pry up. The coupler will pull off the motor shaft.

If you cannot access the coupler due to the way it was broken, simply remove the bottom panel UNDER the oven. With the panel removed, locate the small turntable motor and loosen the mounting screws to remove. The coupler should be easily accessible with the motor out of the unit. Make sure you reinstall the turntable motor and bottom panel BEFORE you try to install the new coupler. The coupler needs to be installed from inside the oven cavity by placing it in the opening in the oven floor and pushing straight down onto the motor shaft.

If you have questions, or require additional assistanc, please let me know. I hope this helps you.

u must remove the broken old door carefully by removing the rubber belt which is connected to the dc motor and bear by there be a white colour plastic which holds the door u must remove that and then u must put replacement & once again u must connect those all properly so it s difficult... just visit technician....