I have a kenmore 70 series washer that won't start the cycle.

flip up the controls

The timer has a hollow shaft. The tip of the shaft has
ears on it. To keep the knob on there a small rod is shoved up into the hollow shaft. The rod spreads the tip and retains the knob. To remove the knob pull out the rod a half inch and the knob and skirt is easily removed.

This video shows how to get into the machine:


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Can you provide the exact Make, Model and Kenmore model number? ..........

Kenmore model numbers use the format ###.######## with the first three digits of 110 for Whirlpool manufactured machines.........

The model number on top load washers is usually found by lifting the lid and looking above the tub.

The Fixya numbers are Stock Numbers. Series numbers (70, 80, 90) only designate the number of "Bells and Whistles" that a washer has and don't reflect the model number.

See the following for where to find the model number:

http://www.american-appliance.com/catalog/newsdesk_info.php?newsPath=16&newsdesk_id=21&osCsid=c73289e58485c8752675ae1a35ff796b

Since basic top load direct drive, top load electronic and front load washers are very different, the actual Model Numbers are necessary to correctly diagnose the problem.

Note after reading a bunch of information. I went home and removed the hose from the Level Switch and "clean it", if you will and re-attached. Started a load, and bingo bango bongo, it work. Thanks for the insight.

There should be a spring clip that holds the timer knob on. It or the timer knob may need replaced. Here is a picture of the timer knob and the spring clip. Sure hope this helps and best wishes.

sounds like the timer to me

Lid switch problem. Press down on lid and try to start machine. Reply.

check the lid switch some washers will fill and was with the lid open but will not spin, if the lid is closed manually actuate the lid switch or bypass it electrically, or replace it.

just pull it off - it's friction - fitted.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

If you are talking about the Cycle Selection knob, turn the washer to an OFF position, or unplug. I can't remember if you need to pull the knob out or leave pushed in, but the knob will come off by turning it counter-clockwise. After unscrewing it and removing, the plastic dial under the center knob will simply pull off. I hope this helps you. If you need further assistance, please let me know.

You probably have a bad lid switch.