My Trendnet router 423 BRP system lights is blinking. I sthere a problem?

You have to look on the tag at the base or back and find the IP address and admin / password sign in to set it up. Set of numbers like 192.168.0.1 or www.routerlogin.net then when on the routers server you can enter your ISP details to get the router setup.

If the unit has been in storage (powered down) for a long time, try leaving it powered up for 20-30 minutes. I think they have a supercap inside that needs to be charged. Once it is charged the unit will power up normally.

How old is the device? May be time for a new device? Has there been any electrical storms? Power surges? Tried different connecting cables? When you reset the device, hold reset for 30 secs., release, wait for selftest, unplug device for 30 secs., plug in, wait for selftest, connect with a Ethernet cable, reconfigure SSID and Security Key.

Try here for a user manual: http://www.trendnet.com/asp/download_manager/list_subcategory.asp?SUBTYPE_ID=1032

Hello
Your going to need to log into the modem/router.Check with manufacturer on how to log in.

Once logged in there should be a page, to turn wireless on.

Here is a link to your router user manual.
http://www.trendnet.com/downloads/list_subcategory.asp?SUBTYPE_ID=1504

you can connect your Ethernet cable from tew-432brp to MT800.

if serial ethernet cable not work you can check with cross cable of ehetrnet also.

Sounds like you may be having an issue with software already installed on the laptop to control the wireless connection. Many laptops have preinstalled software for their internal wireless devices. You should consult your manual about configuring and saving passwords for a network for that particular device. Typically you will need to enter the WEP key in the software itself.

lan wires are the same. lan wires used to connect your computer to your modem can also be used to connect your Wa1003A adsl router and TEW 432 brp.

you just got some things mixed up.

1. you should set your Wa1003A adsl router to bridge mode. At this point, it will just be "pass through" device and will not be the one who will ask for IP adds from your ISP.

2. configure your TEW 432 brp with your pppoe username and password. Your TEW 432 brp will now ask the network for the IP address to that it can connect to your ISP.

3. leave your lan wires the same.

I assume that all lights are on as normal on the router.

Check the System light.

SYSTEM
This indicator blinks green means the Internet Broadband Router is
working successful. Otherwise, this indicator always on or off means the function of the Internet Broadband Router is in a fail state.

If the System light is either always on or off go to step 3 below, otherwise start at step 1.

1. power down router and wait 30 seconds and power up.

Try connecting via 192.168.1.1 then 192.168.0.1 if NO do step 2.

2. disable any firewall programs on the PC

Try connecting via 192.168.1.1 then 192.168.0.1 if NO do step 3.

3. do a factory reset of the router. on the rear panel of the router there should be a small hole with a small button maarked RESET. if you press this in for 10 seconds it should RESET router to FACTORY settings.

Try connecting via 192.168.1.1 and 192.168.0.1 if NO then the router firmware is possibly corrupt or there is some other hardware fault.

Hi Sloan!

Go here and select your Tendnet version from the list. Click on the version. Read the instructions carefully, some updates have to be installe before others. Get up to the latest one, from 10.2007. Should fix your problem.

Good Luck!