Wireless router will not connect to my modem

try to power down both devices for a min than turn them back off sometimes they have to clear MAC address.

Yes, you can connect:

DSL modem WAN/Internet port on Belkin #1

LAN/network port on Belkin #1 WAN/Internet port on Belkin #2

LAN/network port on Belkin #2 your computer

If the two Belkins are in different rooms, and there are more than one computer in the room with Belkin #2, it makes sense to run ONE (not MANY) Ethernet cables from Belkin #1 to Belkin #2.

the cd installation does not work in my windows vista i try to download but it is the same problem

how can i secure my wireless conection

this is because, your ISP may refresh the ip address assigned to you for every 2 hrs.... usually belkin will understand the change of ip address and act accordingly...in you case it is not.... you can log in to router by typing 192.168.2.1 (login password: no password....leave blank and click submit...) clicking on restore factory defaults and reconfiguring the router will fix this issue... if it still didnot, then follow this link below and download the updated firmware for your router version (v1 or v2)....
http://tinyurl.com/33c37x4
once you updated the firmware, click on restore factory defaults and configure the router for your ISP....
Call 1800-2-belkin(235546) for technical assistance to configure your router...

1. physical connection
ISP modem to> router yellow port> router grey port to ur computer
2. modem light on the router should be solid and the internet light also.
3. if not u need to configure ur router
4. open the ie or firefox in ur computer which is hardwired to the router
5. type 192.168.2.1 i the address bar it will lead to belkin router page
6. if the modem light flashes on the router then in the belkin page on the left side click on the restore factory default
7. it will ask for the login password leave it blank click on submit
8. then click on the restore default
9. in the rite upper right corner it has to say connected
10. then disable the wifi protected setup by clicking on it on the left side
11. then u will be good to go with the wired and the wireless connection

then login to router setup page with 192.168.2.1 type this one in the address bar of ur browser
then u will see router setup utility
then click on the restore factory settings on the left hand side under UTILITIES
it will ask u for password leave it blank and click on submit
then click on restore factory default
once it is completed then on the rite top corner u can find the internet status --- it has to be connected or else
u can unplug the modem and routers power cord and wait for 1 min
the plug the powercord of the modem first wait for few seconds till the light are stable on the modem then plug the powercord of the router
then ur internet light should be solid on the router

Try restoring the Belkin back to the factory default by powering up the Belkin and pressing the RESET button on the back of the Belkin for 7 secs. Then connect a LAN cable from the computer to the Belkin, open IE browser and type the configuration IP address and configure the wireless settings ie. SSID, encryption etc. The computer wireless cards will need to be configured with the Belkin wireless settings to allow them to communicate with the Belkin.

your Internet modem or router needs to be connected to the Belkin router's WAN port with an ethernet cable. You'll then need to configure the belkin's wireless settings, it's usually a very easy "follow the prompts" kind of setup.

Verify which MAC Address U have Cloned. MAC Address of Your PC WiFi and Cloned One must not be same otherwise it will not work...

the red light means u havent got a connection if u have installed properly try upgrading the firmware the problem might be the routers
http://www.belkin.com/support/product/?lid=en&pid=F5D9230-4&scid=221