I baught a new black cartage I also have a blue one that is running out but can't get till my s/s Check gets here. I replaced the old black cartage but it keeps printing in faded red. also the blue left side spring has disapeared. why?

Run a cleaning cycle on the print head through your printer utility. Then run a check nozzle test to verify if the nozzles are cleaned. Use only denatured alcohol and a Q-Tip to manually clean the cartridge holder & orifice.

Hi and welcome to fixya
You can print black pages with the color cartage. HOW ? just when you select the size of the paper A4 then ther is an option of colored printing or black if you have ink in the color cartage then it can be done that you can print black pages with that cartage
thanks hope that will be helpful

Hi, the 2 - brown wires are for there own run capacitor they should have sold you. One of the browns will have a white stripe. The new cap has only 2- terminals and you put a brown on each side. The black and yellow wires are both hot which 1- will go to 120 volts on the load or out side of the contactor, and the same with yellow, 120 volts. This gives you 220 volts to run the motor. Look on the new motor and you will have a diagram or on a paper that comes in the box. The old motor used the dual cap to run the compressor to. The green is just a ground wire. Screw it to any metal part or screw. You should be able to put the black and yellow hot wires where the old black, red, or blue were as long as they are 120 volts which I am sure they are. Get a cheap tester when you go get the cap for the new motor, and check the old blk, red, and blue terminals to ground and you should have 120 volts on at least 2 of them. Put the new yellow to 1 and black to another, browns to the new cap and your off and running. Keep me posted. I do this everyday. Please be kind when rating me, thank you.
Shastalaker7
A/C, Heating Contractor

Maybe you need new black ink cartage, or new color if its one pint cartage. follow the procedure under the bonet to change the ink cartages,. hope this helps

i think it is cartage fault. drum of cartage do this many time. while we reffil dust of cartage we face same problem. once atime check changining another old cartage. u came to know problem.(nepal)

On the right side of the printer there should be a tab where you can open a compartment. this will let you access the cartage. Check and see if you forgot to remove the plastic tab. Also if the cartage is defective return it to staples and they may give you a refund or exchange.

in your cartage have green cheap or fuse these are reseter. the are aviable in market .change it . then your printer can work. when are u getting tonner low. recently u shuld fill cartage. i think you get empty message. just reseting cartage by new reseter than u can change old reseter. u can 100% solve your problem thanks

pull the ink cartage back out to see if a clear film is not on the cartage??? Check the area by cleaning the ink cartage with rubbing alchole, and also the area that the ink cartage goes into. Use a cotton ball the clean these area with.

if their cartridge worked and yours did not. buy a new cartridge.

that same thing happen to me try to wipe the needle that the ink is on with baby wipes.