Question about Sony Cyber-Shot DSC-W1 Digital Camera

1 Answer

The door is stuck open, how do I close it - Sony Cyber-Shot DSC-W1 Digital Camera

Posted by brfam5 on

Ad

1 Answer

Lori Hebeler

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

The two little clips that hold it closed are more than likely broken off or damaged. you need to replace the battery door.

Posted on Dec 04, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My GE dishwasher door is stuck closed


Have you tried wiggling it side to side? The diswasher may not be secured properly and will vibrate while running. If the counter opening is relatively small it can be hard to open the door if the dishwasher is off center.

Mar 15, 2015 | GE Dishwashers

1 Answer

Trunk latch is stuck, door will not close toyota matrix 2003


try putting a screwdriver in latch while opening with the handle you might have hit it and closed latch when door was open

Feb 18, 2015 | 2003 Toyota Matrix

1 Answer

How do i manually retract - Exterior door stuck closed - removed knobs (levers)


PUT A SCREW DRIVER IN THE HOLE AND TURN IT

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/joe_0ca6379e2eceb740

May 25, 2014 | Kwikset Lido Polished Brass Entry Lever...

1 Answer

Drivers side sliding door won't close


check mechanism on working doors. In my car if I move the catch on the door(click it like in closed position)like it was closed,then when I open the handle it releases open;this shows me closing/opening. Spray penetrating fluid on the metal/mechanism,possibly rusty and prevents smooth actions. Hope this helps.

Jan 01, 2014 | 2004 Nissan Quest

1 Answer

2012 HONDA ODYSSEY DOOR STUCK OPEN


It's possible the fuel door was left opened when the power slider opened? Turn off the power slider switch on the left side of the dash board (left of the steering wheel), then manually close the slider. Close the fuel door then turn the power switch back on. If it continues to jam, turn off the power switch again and open/close manually until you can get it to the dealer.

Jul 26, 2013 | Honda 2012 Odyssey EX-L

1 Answer

Unable to close door


I have 2 different door problems with my 99 Park Ave: one door opens more than it should and often can't get it to move to close it and the other door opens but when trying to close it, the door will not latch closed. I'm not exactly sure what you mean by door wouldn't close, but with your mention of the metal parts, I'm gonna take a guess that it doesn't latch closed (kind of bounces back open too). For that problem I do 2 things to avoid actually fixing the problem. First, I check that the door handles are in the closed door position (my outside handle stays stuck out in the pulled position); I push them both in. If that doesn't work, I push down on the latch mechanism in the edge of the door to find that it was stuck in the open position. Once I do those 2 things, my door closes perfectly.
I hope this helped!

Jan 30, 2012 | 1999 Buick Park Avenue

1 Answer

Have a 1998 Jimmy, the driver door is stuck in the close position and can not close the door. The handle seems to be working properly; inside handle moves the cable that permits the door to close and...


with the door open see if latch is stuck in close position . If so hold handle open and pry with screwdriver to open latch ..If that works latch needs to be lubed for smooth operation

Feb 17, 2011 | 1998 GMC Jimmy

1 Answer

Model 565.66400, still runs when door is opened?


if unit runs with door open then one of the door switch is stuck closed.there are 2 door switches and they could be assesed by removing the control panel.disconnect wires from top and bottom switches and chkf for continuity.they should be normaly open when the door is open and closed when door is closed.one of them will closed even when door is open.replace that bad one.

Aug 11, 2009 | Kenmore Microwave Ovens

6 Answers

I have a Craftman Garage Door Opener Mod#139.53650SRT. It closes completely then goes back up. I replaced the sensors @ the sides of the door to no avail. I have tried to adjust the up and down on the side...


I agree with the closing resistance may be set incorrectly, all openers have a safety feature that senses if something is keeping the door from closing, this is back force, you set the sensitivity at the back of the opener motor control, it is a little dial, reduce the setting just enough to stop the door from kicking back open when it closes, I had this very same problem with my craftsman and this adjustment fixed it.

Oct 08, 2008 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

My DVD Player does not reject a DVD. It gets stuck.


I had been closing the door at the DVD slot manually. I found that if I closed the DVD door with the close button, and then opened it with the open button, it no longer got stuck.

Jul 04, 2008 | Philips Televison & Video

Not finding what you are looking for?
Sony Cyber-Shot DSC-W1 Digital Camera Logo

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Cameras Experts

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Harrie

Level 3 Expert

6746 Answers

Brad Brown

Level 3 Expert

18563 Answers

Are you a Sony Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...