I have a Infocus Screen Play 5000 bulb has 324 hours the picture is light green.

Your bulb provides the light,the projector provides the image so it would be your projector.

Hi I am Vortash check in your user manual this may be the signal to tell you that the projector is telling you that the number of hours for your bulb is up ( or indeed the bulb may have blown but this usually shows a red light if so ) if the bulb life monitior is at it's extent it wont let the light opperate and you have to reset the lamp hours you can find out how to do this in the manual under replacement bulbs .. if you have no manual you may be able to download one from off the net .from the manufactures support site .alternately you may have a ballast problem and it requires an engineer to sort it out . regards Vortash

reset the settings to factory default. if that did nothing, you have an lcd problem. the ribbon cables may have come loose from the main board, or the polarizers are fried due to excessive dust and heat.

there is an issue with the lamp ballast. probably needs to be replaced. send it in to an infocus service center. try av solutions in ny. they're really good.
i think it's www.avsolutionsny.com

check the lamp again. look in the reflection in the bell of the center glass. do you see any black spots or cracks or uneven bulging? if so, change the lamp and blow the dust out, because it may be over heating. otherwise, the power supply is fried and needs replacing.

the power supply is bad. there is a fuse on it, but it wouldn't be a occasional problem. the caps on the ps board may be drying up and causing it notto function. replace the ps.

Yes it sounds like the LCD controller has died or dying if still under gaurentee take it back if not it wont be worth repairing.

Marc Engineer

Very likely your bulb. Could also be your ballast.

the light polarizer on one of the lcd panels is fried. bad news: you'll have to replace the entire optical engine. worse news: infocus no longer sells them. sorry.

depends on how many times the orange light blinks also when you replaced the lamp did you do a timer reset? you can find alot of information on how to trouble shoot this www.infocus.com/support