Avery DesignPro Error while initialising

Suggest you try the free Avery online solutions available at the link below.

Templates Microsoft Word Templates Design and Print DesignPro Avery

I have been having the same problem. Following the directions found here http://www.avery.com/vgnfiles/OP/en_us/Help%20Center/staticfiles/DesignPro%20for%20PC%20Help%20for%20Windows7.pdf will mostly help but I am still having other smaller problems. I think I am going to have to phase away from this software overtime.

there are very few free softwares for MAC, but try this one:

http://www.avery.co.uk/avery/en_gb/Templates-%26-Software/Software/Avery-DesignPro-for-Mac.htm

Some CD label software allow you to adjust the "overprint" by resizing the image you are printing. If your software doesn't allow you to size your image larger than the label (so it overlaps) try a different program. Look for a setting that allows it to over print. It's not an exact science...you just have to try to make the adjustments you need. There are also different CD/DVD label sheet types where the labels are setup on the sheet differently. maybe a different setup may work better. However, usually Avery is pretty good.

Avery DesignPro should get you printing quickly. (It's Free)

http://www.avery.com/avery/en_us/Templates-&-Software/Software/Avery-DesignPro-for-PC.htm

After you tell the program to print, you will be queued for the number of labels or sheets of labels you want to print.

It should but check the Avery website for any downloads for Vista if you have any problems. Let me know if you have any problems.


Thx

you may need to use some free software that is available for 10.4 and 10.5 users. produced by avery it is the DESIGN PRO available for download at http://www.avery.com/avery/en_us/Templates-&-Software/Software/Avery-DesignPro-for-Mac.htm

also available for PC
a bit awkward to learn, it does the advertised job

paxar 636 diagnostic test 2. i've encounter this problem last 2004. the diagnostic test stops at diagnostic 2. what we did is that we've checked the mother board and the printhead board. basically those boards are the main problem when you encounter that error (diagnostic test 2 error ). what we did is that we changed the mother board as well as the printhead board.

If you have Microsoft Word, you can open a template of the label you're using (which is free from Avery if it isn't already in Word) and make that document into a mail merge document.