Scanner noise Replace scanner motor? Error 71.

machine error 71 "Scanner motor does not synchronize with the reference clock."

Check:• Scanner motor

Steps to troubleshoot the Brother Printer Error Code 71
Step 1:Verify the firmware rendition
To guarantee the Brother machine is dealing with the ideal settings it is prescribed the machine to have most recent firmware
Press * and # keys at same time on numeric key cushion of the machine board
When a few letter and number presentation top line of the LCD, in the event that it is P or higher than it is fine form to be utilized or if the firmware rendition is N or lower you have to refresh
When the update is finished move to subsequent stage
Step 2:Turn off the Brother Machine power switch and after that walk out on
Stage 3: Print the User Settings by squeezing MENU, 6 (Print Reports), 4 (User Settings), START.
On the off chance that the User Settings are printed accurately and the mistake won't return, and the issue has been settled.

.If facing any problem related to a printer please visit us Brother Printer Error Code 71.

Error 71 on a MFC-9600 means there is a problem with the motor inside the printer.
You can try unplugging and waiting a few minutes, then plugging back in again.
If it is still coming up with the error, if its still under warranty Brother will replace/repair it for you, otherwise you will have to pay Brother for the repair cost.

The error code 71 indicates a problem with the scanner motor for document feed. Could be timing problem, or motor problem. If tries to feed documents probably timing, no feed motor.

Laser scanner motor does not lock

sometimes people use different names for these two items, but "scanner" to me as a tech, is the assembly with the light under the glass. the error 71 points to your "laser" unit which is pretty deep inside your machine and most likely, only a tech would be able to replace it. once replaced, the code will automatically reset.

hth,
razors

Stepper Motor Failures
Within the first 6 months of purchase I had to return the scanner twice to replace the stepper motor. The symptoms of stepper motor failure are a loud grinding noise during scanning followed by the enlightening message:
"The scanner has reported a hardware error. The present function cannot be continued. Sense: 0x04620000"

service required to fix stepper motor

Error 71 is a laser scanner error.

Inkworks
866-381-0541

Paper jam 71 is an error that occurs when a driver on the controller board (IC-28) begins to wear out, or the timing gets thrown off. This causes one paper feed motor to drag the other one. This error is normally accompanied by a loud grinding noise because of this. Kodak's newest firmware version is supposed to fix the problem. If that has no effect then the fix is to replaced the controller board.

Good luck.

71, Polygon motor does not synchronize with the reference clock
This means you require a replacement scanner/printhead