I need a leg for the dwell studio silver lake crib in espresso/white. mine came with two of the same sided legs and the bed can't be put together until I find the opposite leg. Does anyone know how to get these parts as well as an instruction manuel for the bed?

I have the part to convert this crib to a toddler bed.

http://www.summerinfant.com/Help-Center/Product-Instructions.aspx?category=%2fProducts%2fNursery&order=nameasc

You can locate the instructions for Carter's cribs at the above link. This should help answer your questions.

F32701.03 is the model for your crib. Are you trying to convert it into a full size bed? Baby's Own Room sells the full size conversion kits.

You need 122-dc, hard to locate. It comes with the legs, apprently this is the version of the bed made in China, the Brazilian version the legs stay attachted.

Take a look on amazon for additional parts here
Amazon com sorelle espresso toddler bed of course its not worth to buy another new bed. cheers

Part needed: Allen Wrench

Safety rail
Safety rail bolt

Make sure the mattress support in in lowest position. Remove the front top rail and front panel. Attach both safety rails ( small side pieces) to the crib end leg using the safety rail bolts.

Nevermind........... I think I found the soloution
they included the wrong instructions with my crib. They included the instructions for an old model
i need to get the toddler attachment because it supposedly has legs
will order it and hope it does what they say it will
** fingers crossed

Okay, this is how I solved the problem.  There is a small "wrench"-looking thing that comes with the crib and the trundle drawer.  You have to take the wrench and put it around the rod between the wheel and the leg cover on the crib (where you inserted the caster).  You have to pry between the wheel and the leg cover and it pops off. 
Three of mine came right off, the fourth one took some "mmmmph" to it (and about 3 minutes -- a major pain in the booty).
Hope this works for you.

if you have the conversion kit for the crib to convert to a toddler bed, you should also have the white caps that go one the end of the guard rails for the toddler bed. I found with mine that they are the same ones as that are on the stationary side of the crib on the back side. if you do not mind having a crib with out a drop side you can remove both tracks and take those pieces and make it a stationary crib by merely following the way the rear side is put together. I have done it with mine as a guide was broken on mine. there should be four caps in the conversion kit that go on the two rails on the front side when you convert to a day bed. I figured out that they are the same as the ones on the back because you do actually use the ones off of the back side when you make it a toddler bed and put all four rail on.

I have the opposite problem - I can put it together as a toddler bed. The trick with that is that you put one of the long screws through both the hole at the SHORT end of the toddler bed side AND the metal flange from the springs into that end of the crib. The other long screw goes through the raised end of the toddler side into the end of the crib - where the child's head would be.

Is there supposed to be a plastic piece at the top of both ends of the crib on the side that does NOT go up and down? I can't seem to figure out how to put the crib side on.