I have a kyocera FS-2000D with error code: Call for SErvice 0150:0000049. Help...thanks in advance

Call service message 6000 in Kyocera is a fuser error code. The fuser must have gone bad.

Regards,
Shrey

Error code 0150 is an engine EEPROM communication error. The engine board might need to be replaced. I have heard that sometimes a defective developer unit could cause this same error code. I would try swaping a develper from a working FS-2000D first.

This seems to be a fuser error. You need to take it to your local sevice agent for repairs.

This error code means that the Laser unit in the machine has failed and will need to be replaced.

I have heard that 7410 is a standard code meaning the drum is out of position. Seat the drum correctly and away you go.
David
www.copycare.net

The files called 2000sys.zip & 2000_eng.zip I beleive, if that helps. I bet after you have updated the firmware, you will find the serial number absent from status page, muz get corrupted when the engine firmware chucks the 150 error, Just thought I'd say although is not norm a problem

Oh, It only ever does the 150 once, never if firmware is updated.

open the left side door and push in the drum unit firmly. it's the part above the waste toner

Hi, switch off printer ,just open cover(door) on the left side of the machine and push Drum Unit in machine(to proper seat)
You have to hear "click" sound.Switch on printer.
Regards...

I couldn't see a 159 error in the 2000d service manual, but I know 150 errors . They need to have their firmware updated, should be under warranty, their is a kyocera service bulliton on this issue so all agents can do your repair. It is just a matter of downloading firmware from kyocera. unzipping it to a mem stick or CF card and powering on your printer with it inserted, firmware then self installs.

The bits after the 159:is just page counter. Post Email if you want me to send you zippped firmware to suit.

install new firmware