Cooktop red light is staying on

Your are not quite specific about what kind of a cooktoop ypu want to replace:


DIY How To Replace Gas Cooktop

Whirlpool Cooktop Broken Glass Replacement Model RCC3024

ge electric glass cooktop board glass replacement

Cooktop Main Top Replacement GE Electric Cooktop Repair Part WB62X10047


You can search for more using these terms with COOGLE

Youtube Replace GE cooktop

so sorry for the way late reply!
if the knob does not fit you'll need a new one...
i found them here....
https://www.repairclinic.com/Shop-For-Parts/c31-x72636333303234/Rcc3024-Knob-Dial-Button-Parts
not sure which is yours as the model # should have a few more # or letters. Take a look at them and see if one matches.
best to you.

Since you have a red wire you must have 10-3 romex. 10-3 has four wires. Three jacketed wires Red, Black, White and a bare copper wire. The is Red and Black are your two 120 legs (both hot) white is neutral and the bare is ground.

If the hotplate 'hot' light is on when the cooktop is completely cooled down then you will need an experienced repair person to fix it. It can be a bit complicated.

spring tension issue....adjust the tension :)

most cook tops the light that maches the burner is on if sw is on . if light doesnot fo off replace that sw . if only one light for all burners you will have to fint the shorted one.. good luck mm ..

if its going out, its probably ok
its not a light indicating the burner is on, rather that the glass is abcove 100 degrees and still not safe to put something on
2 hours is a bit long but it depends on how fst the surface can cool of
you can test this by trying to cool it off faster with a fan ans see what happens

Hi again,

It would seem you posted anew.

For some reason I could not locate related literature for a RCC3024LD01,although there are for LB01, LQ01 and a LT01. Most of the components inthese models could be checked with the use of a continuity tester(multitester VOM/DVM). The idea is to check for continuity of eachcomponent. If we are to assume that the heating element as a likelysuspect, it is a matter of checking if the coil is continuous, that isno break anywhere in between. The test prods of the continuity testerwould be applied to the two (2) terminals of the heating element andthe tester should deflect/display how much is the resistance. Normalreading shouold be pretty low while no deflection/reading indicates anopen coil and therefore would require replacement.

These additional documents may be of help to you:

1. exploded parts diagram;
2. parts list.

Cheers.

Hi,

Initially, it could either be:

• open heating element (most likely);
• open temperature limiter (least likely);
• faulty/loose connection/wiring (a possibility).

Please confirm that it is a Whirlpool RCC3024 Electric Cooktop.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information. Good luck and kind regards. Thank you for using FixYa.

youl have to pukk out the unit and check the connection/installaiton. youll need to determine if you have proper voltage going to machine. ther if no fuse on the machine, more than like a power supply issue