Jvc 52 rear orijection top has doulbe image in

FYI the convergence ic's need replacing also any burnt resitors.
not a job for amateur, get a professional to do the job.

the ITC222 and ITC222A convergence option missing repair kit from www.tvrepairworld.com usually repairs that issue. The kit contains the parts and the CD with instructions

Sounds like you have a defective Red CRT drive board. Heres where you can get a replacement one.
http://servicemanuals.vstore.ca/product_info.php/pName/itc222-red-crt-drive-board/cName/rca-parts

Hi and welcome to fixya, it is the colour wheel problem,,,,,,,,,this is common problem please check it ...it may be also cathode ray tube... thank u.........

Sounds like your convergence is off. Go into your menu and try setting your convergence. If you can not move any of the colors you need to have your convergecnce amplifers replaced

Remove front grill and chip board ,there are three knobs one is for brightness I think another for a sharper picture (best to use while convergance adjustment and the third which should balance your
black or white screen to have blue,red, or green tinge ,you like to have it as neutraul as possable.
if you are stll getting everything in blue,green or b-52 agua marine ,your red lamp may be burnt out!.

i would call a repairman out and have it fixed..it would be alot cheaper than buying a new tv.

I was searching online about what could be the problem with our TV and I came across your page. We have a 52" JVC Projection TV that now has a "blurred" screen. We can see the channels but it looks like it's has a shadow around the images. The screen in in a red hue with green blur.

If you have any suggestions on what caused this and what we can do to have this fixed, I would greatly appreciate your advice.

Check that the 3 output plugs are in the right sockets (Red, Blue, Green) There is usually a felt pen colored mark on a white tape on the plug in wires. The Board sockets are marked Red, Green, Blue.

Easyab

ok go into setup menu.... go to convergence.. try to adjust convergence .. does the crosshair move up and down side to side... if not then you might hqve q poblem with convergence power supply if they move then u might have s setup issue