Initial charge to battery for Casio ex-z77 camera

The EX-Z77 is not a battery charger. It does not charge via the USB port. You need to remove the battery from the camera and put it into the supplied battery charger.

If you need a manual, you can download one at
http://support.casio.com/pdf/001/EXZ77_e.pdf
The battery charging instructions begin on page 36.

You can buy from the following web sites:
http://www.bestbatt.com/Casio_NP_20_Battery_p/bbcasnp20-01.htm

http://www.calcellular.com/casio-np-20.html?gclid=CNTYvOLdo6YCFRZ-5Qod1Us3pQ

http://www.overstock.com/Electronics/NP-20-Camera-Battery-and-Charger-for-Casio-Exilim-EX-Z75-Z77-S770/4384370/product.html

http://www.shopxtreme.com/pages.php?cID=4&pID=11&gclid=CMu9ypbeo6YCFYHc4AodGifKnw

hi, once you charge your battery and the red light blink it means your NP-20 battery is damage and you need to buy new one.TIP- charge 1.5 hours only and if youre not using you camera for a long time its better to remove the battery.

good luck and thank you my friend

Your battery maybe drained, you can try to leave it in charger for hours( it will take long for a drained batt to start charging) blinking led may indicate that charger is trying to supply current to batt, anyways I strongly suggest you to buy a new one

what you need to pups is you have to buy a new camera

Battery is faulty, it has been left to long discharged & has anodised up on the inside. Buy a new battery

turn it were it would turn on then trun it of then back on

buy a new battery (DUH)

Aye, jpierre's solution was right on the money. Touch the positive (+) end of the 9v battery to the positive (+) end of the camera battery. Leave them touching for a few seconds (10 seconds should be more than sufficient). Seems these lithium-ion batteries are subject to a 'digital memory.' Subjecting it to a volt surge almost three times higher seems to clear it.

http://www.batteryuniversity.com/parttwo-34.htm

In short, it works like a charm. Thanks jpierre

Here is how you fix the problem (without using a 9V battery method...).

The battery doesn't charge because it's been fully discharged.

What you do is you put the camera into the cradle. Now you see that the Red LED comes on solid for a while. It's charging for a few seconds. Then it starts blinking. When it does that - TAKE THE CAMERA OUT of the cradle.

Now put the camera back and repeat. Do this six or eight times. Each time what's happening is that the battery is getting a tiny bit of charge. After 8 times the LED will come on red and stay solid red.

Bingo, no problem!