Vs3251 my power supply is not working where to buy replacement?

Did you get a solution of this problem? I am also facing the problem.

You're in luck...

Someone's selling the speakers and a remote on eBay...

http://cgi.ebay.com/Altec-Lansing-VS3251-Computer-Speakers-Remote-Control-/280620941058?pt=PCA_Speakers&hash=item41564fbf02

If the woofer LED is not working then you may have a power supply issue in the woofer. Try unpluging it for a while and see if it resets. Otherwise, you may be looking at a power supply repair.
I hope this information allows you to resolve this issue.
I am doing this for free.
If I have helped you, please help me, and rate this suggestion the highest FixYa rating. (Two Thumbs Up)
If you need further assistance please comment to this post and I will try to help you further.
Thanks for using FixYa
asnowman

Hi

You can download the following pdf to learn more about connect your speakers

http://www.alteclansing.com/images/quick/VS3251-QCC.pdf

Because this system is made to work with the PCs, it has a 3.5 mm stereo input. The 360 has rca cable outputs. Fortunately, the signal is the same and all you need is a 3.5 mm to rca y adapter that you can find at radioshack or any local electronics store.

Any internal slow-blow fuse can be replaced with one of the correct value. Fuses do seem to have a finite life, so occasionally you can just replace the blown fuse  with an identical one and all will be well. However, fuses are protection devices , and it's more likely that you have a  short circuit or  defective component in your VS3251 that's causing it to draw too much current , and the internal fuse is blowing to prevent further damage. ie the fuse blowing is the symptom not the problem. Never replace fuses with ones of a higher current rating. Slow-blow fuses have the suffix T (for "Time Delay", and normal ones have F ( for "Fast"). With the street price of the VS3251 , a commercial repair is uneconomical

Philips DVP 3256 has 6 outputs which takes in RCA connectors
Altec lansing VS3251 has 3 STEREO outputs.
Buy 3 nos of STEREO (female) to RCA (male) cables
1. Connect the Altec's green wire to first stereo-to-RCA cable. RCA ends to DVP 3256's Front left and Front right
2. Connect the Altec's black wire to second stereo-to-RCA cable. RCA ends to DVP 3256's Rear left and Rear right
3. Connect the Altec's orange wire to third stereo-to-RCA cable. RCA ends to DVP 3256's Centre/Sub woofer. Interchange RCA ends if the Subwoofer sounds dull.

Good Luck

ya what u wann know

try and download sound softwares from majorgeeks.com.

hope this works.