I have a DreamMaker Escape. It was brand new as of 12/2009. I drained it this weekend and now the pump will not start. Power is good, it's reading water temp, display works, but the jets won't come on. It just clicks 2 times and then nothing. Any ideas? Thank you!!

The sensor should be located near the oil filter. I did not have to drain oil to replace. If car has that many miles on it yes pump could be bad.

Some have a electric heat element, while some others have a "Exchanger" system utilizing the heat from the pumps motor to transfer that heat to the water. Pump will be on a lot!

This might be a problem with the topside control. When the spa is clicking, try unplugging the topside control and see whether or not the problem stops. If the jet button is stuck on the topside, the pump will turn on-off-on-off-on-off until the topside is unplugged.

If unplugging the topside worked, replace it.

The dr error code is for "dry". Meaning that the control system is not sensing that water is flowing through the heating element.

With a new spa, and you just having drained it , it is probably an air locked pump.
What this means is that you have a small constant circulation pump with not much power, that got ait trapped in it when you drained. When you went to start back up, this "air lock" prevented the pump from fully priming.
Power down the spa at the breaker. Remove the filter element.Stick a garden hose with lots of pressure into the skimmer hole and open the hose valve to let water inject into the skimmer.
Restore power to the spa and check operation.
If after attempting this a few times you still get the code, there is an issue with your flowswitch, or with your circulation pump.
With a brand new spa, id like to hope that you just have an air lock.

Good luck

Sounds like you need a new power steering hose. To verify this, I would dry up any wet areas on the hose and pump with a towel, get a flashlight and start the vehicle and try to determine the exact site of the leak which is usually at the ends of the hoses. Good luck!

Turned out to be a fuse, contacted the local dealer directly and they said dreammaker has changed vendors on the control box unit and
they have been having problems with the 250V 15Amp fuse.

Suggested that I go to a 20Amp, but that I should contact dreammaker
directly