Error code on washing machine wf640

what's f24 code? - Kenmore Elite HE3 Washing Machine ...

https://www.ifixit.com/Answers/View/85549/what's+f24+code

iFixitAug 21, 2015 - Aiman, The F24 error code indicates a water temperature sensor reading that is ... The Kenmore Elite HE3 is a washing machine by Kenmore.

F24 Error Code on My Kenmore Washer ' eHow

www.ehow.com > Home

F24 Error Code on My Kenmore Washer. Kenmore washing machines have several high-tech features, such as a stain treatment option, reduced energy and ...

Kenmore HE2 Plus Front Load Washer F24 error code ...

www.fixya.com > ... > HE2 > Kenmore HE2 Plus Front Load Washer

...error code F24 I have a Kenmore HE2T washer and I keep getting an F24 error on it.. I have no idea what is means can't find the manual help!!! The "F24" error ...

I have a Kenmore HE2T error code F24 - Fixya

www.fixya.com/support/t3608391-kenmore_he2t_error_code_f24

Dec 9, 2009 - Posted on Dec 09, 2009.

Water up to door level means your motor and motor control unit (MCU) was covered with water. Most likely your Motor control unit (MCU) is damaged rather than Central Control Unit (CCU).

Listen, you have to buy a new machine. If you end up putting CCU and MCU both into a soaked wash motor washing machine, you will be so mad with yourself.

Time to go to Home Depot looking for a new machine.

You use that flooded machine then all your washing machine warranty and liabilities from the manufacturer is out of the door. Even your home insurance may not honor if you knowningly use a flooded machine and something goes wrong.

The error indicates a problem with the incoming water supply.
Check for restricted or kinked inlet hose/s, check that tap/s are fully turned on and that you have adequate water pressure.

the pipe you are using is too small for the amount of water you are forcing into it

F02 indicates that the motor tacho has broken or become detached, this is to be found on the end of the motor shaft.
Pleawse rate my solution.
Thanks.

You need to check the pressure switch and tube wich you can access from the top of the machine with the top removed. the tube is a rubber pipe which may have fallen of the switch or pressure chamber connection. cheers

check the drain pipe is not blocked, to empty the machine manualy get a bowl on the floor and lower the drain pipe into it and fill to stop water flow lift pipe up in air and lower to start draining again when empty if pipe not blocked i would suggest a new pump located under the drum and easy to fit

PLEASE INSPECT DOOR BOOT (RUBBER DOOR GASKET) IF NOT CAN BE FILL VALVES NOT COMPLETELY TURNING ITSELF OFF ,,, IF ALL LOOKS GOOD REPL/ PRESSURE SWITCH

hi sounds like a faulty fill valve easy fix

the f-01 error code on your hotpoint all in 1 washer/dryer is a short circuit code for the motor. the only way to clear the code is to have a service tech come and inspect the reason for the error.