My cell get freeze when i finish a call and push end call bottom

1. Top end is the replacement of cam, lifters, push rods, rocker arms, valves, valve springs, valve guides, valve oil seals, cylinder heads resurfaced, and checked for cracks. (Magna fluxed)
2. Bottom end is engine block resurfaced & checked for cracks, Cylinders honed, crank bearing resurfaced/re-rounded, crank rebalance, new crank bearings. New connecting rods, new rod bearings, new pistons, new piston rings, new freeze out plugs, new front & rear crank seals, new oil pump.

have someone professional come and check it to confirm what's the problem.

i found that pushing down on the left of the screen (bottom if its opened) will stop it from doing that for the most part, my phone does it too, probably a loose internal connection, or at least it was, untill it stopped turning on completley...

you should have on your XP service packs 1&2 minimum now available service pack3

The battery cover release is located on the bottom of the mouse near the end. Push the button and the top will pop off so you can have access to the battery. When finished replaceing the battery just push the cover back on.

Buddy
Corporate Computer
www.ccl-la.com

there should be a quick disconnect about 4 inches from the bottom of the door. look behind the toe kick. if it leaks from the disconnect try pushing the plastic lines into the disconnect. the disconnect is about 1.5 inches long and should have red or blue ends. to get the lines out you push the colored ends in while pulling the plastic line out, try cutting off the ends smooth and straight up and down and re-insert. if the water is coming out of the bottom of the door you need to replace the water line in the door.

to get the line out of the door. use a flat blade screwdriver to pry the dispenser cover off the door. there are two slots on the bottom of the dispenser facia. use a pen or something hard for a pivot point and use tape to protect door finish. push on the screwdriver until you think the plastic will break, then push a bit harder and it will pop off. now you can disconnect the facia and remove the screws holding the switches etc. disconnect the water line and pull it through the dispenser. to put the facia back on just hook the top and line it up and press the bottom back on.

When you run apps and use web especially when watching online videos, ram of your n95 quickly start ending.When the ram completely finishes, your phone freezes and reboot.So you should continuously clear private data while browsing and don't run more than one software at a time so you can save the ram.

I hate to be the bearer of bad news but phone freeze is pretty much the end of the line. That is a security feature in the base firmware. If a security code is entered incorrectly too many times, the phone completely locks up. At that point, it is pretty much useless.

Samsung has implemented this so that you have to send it back to them.

Unless you know someone that can reflash the main firmware, its bricked.

Please be fair and at least rate as helpful, because there really is no "fix ya" solution available for phone freeze.

At bottom hinge of freezer is the water line to door. Undo connection in line. It may be a quick connect. To undo push in on one end flange to release, and pull out line. Put bowl under end from under refrigerator and make sure doors are closed. Now push water dispenser and see if water comes out line. If it does, the line is frozen in the door. They had some models that had air leaks in freezer door. This causes insulation to freeze and water line freezes. Push in on inside of freezer door and see if it sounds like snow crunching. If it does it's probably frozen. Also peel door seal back a bit and see if is held on by numerous screws. If it is, it may be one of them that freezes. Call GE. They may still have the program going where you get 2 new doors free. Give them your model and serial numbers.