I have a liftmaster pro 1/3hp opener. the yellow led blinks in a steady pattern and the remote works intermittently. This happened a few months ago then it mysteriously cleared up

1. Change the battery in your remote 2. Are you using you remote in the same way as your wifes, ie on the cars sun visor, try putting both remotes in the same location and activate the garage door with both remotes several times if yours fails your remote has an intermittent fault.

It sounds like you have a loose connection. Pull the logic board and check for bad connections especially around the small transformer.

Make sure the keypad battery is good. If that isn't the case your keypad is bad.

If that LED is blinking a code let me know what it is. For instance 5 blinks and a pause then repeats. If it is just blinking randomly that is normal.

tell listmaster. maybe new board is n/g

Just fixed this problem tonight. Had the 5 blink/flash thing. Opened it up and saw that the motor wasn't spinning so it wasn't a bad rpm sensor. Jumped the red to black and then the blue to black to verify motor worked. At that point assumed it was the logic board not telling the motor to start, but I could hear the click of the relay. Pulled the logic board out and noticed a solder joint that had failed directly behind one of the relays. Resoldered that joint and the garage door opener worked again like a dream. Hope that helps someone else.

It sounds like the wall button has the lock feature engauged.

Is there a small green LED flashing inside the wall button?
Push and hold the lock button for about two seconds and the LED should stop flashing. This will unlock the garage door opener and your remotes should start working. You may have to reprogram your remotes and homelink again since you triedprograming in the lock mode.

Good luck.

• Stuck remote control button. Check all remotes. check LED on receiver.
• Staples around Multi-Function Control Panel bell wire could be cutting into that wire. Remove wires from opener and test. Replace staples causing intermittent short.
• Multi-Function Control Panel could have sticking door control push bar. Remove wires from control panel and test. Replace control panel if defective.

I looked up the manual online - after you replace the bulb, you need to reset the bulb life timer. Using the TV remote push the menu button, SETUP menu, select the lamp reminder option to reset the hours to zero. That might help the status indicators.