Change Blade on Venetian Blinds

Vertical Blind Removal - YouTube

? 1:42
https://www.youtube.com/watch?v=DzjFN-6Ggsg
Aug 21, 2012 - Uploaded by Victory Curtains and Blinds
Vertical Blind Removal. Victory Curtains and Blinds ... How To Replace Vertical Blinds Changing Headrails ...

How to Remove and Install Vertical Blind Vanes - YouTube

? 0:44
https://www.youtube.com/watch?v=2FsauNXkRdw
Jun 10, 2013 - Uploaded by fixmyblinds
This short video will walk you through an easy way to bothremove and install the vanes on your Vertical ...

How To Replace Vertical Blinds Changing Headrails Taking ...

? 11:08
https://www.youtube.com/watch?v=XPgtms7rnQ0

if they are that far gone I would just replace them. I don't know of any way to remove tar stains. The time that it would take to clean them would cost you the equivalent of buying new blinds.

Jason'http://shutterupbus.com

it is due to the change in the light patterns

if you take a pic of TV or PC monitor the image look like venetian blinds

this is the reason

I have the Hunter Douglas PowerRise blinds and it is a nightmare every time the batteries die. I can't figure out a consistent way to get them to reset properly. I've called their support line. Hasn't helped much. Since they're in my guest room, I haven't cared for the past few years. But now I have guests coming, and it's a real bummer that I have to replace my blinds. Guess I'm not buying Hunter Douglas next time.

Not sure if you have vertical or horizontal stripes but here we go

THE BUFFER BOARD ARE NOT EXPENSIVE ABOUT 100 DOLLARS IT TAKES ABOUT 30MIN 45 MAX
TO REPLACE . AND VERY SIMPLE TO REPLACE.

Replace C2P08 100ufd/16v (capacitor) off of pin 3 of IC2P03 3.2v reg ( on signal board )

OK this problem is caused by a failing electrolytic capacitor back in the power supply. It's job is to filter AC interfence from that voltage source. Locating the correct capacitor is something not for a do-it-yourselfer. A respectable tv shop experienced with Mitsubishi tv's can usually repair this problem in your home. Average repair cost would be between $200 and $300.

there are plastic gear inside of the top rail. you need to take the blind down and look inside. it may have some of the gear damaged. in which case the gear need to be replaced. unfortunately, there is no place sells the gear. only the rail.
that means you have to buy a new rail and go through the trouble of re-thread all of the control lines. if you are not handy, I suggest you take the blind to a repair shop.

If you're having like a bright picture with venetian blinds, you could try the steps below:

POWER RESET:
- Turn off camera
- Remove batteries for a minute
- Return batteries
- Turn on camera

MASTER RESET
- Turn on camera
- Press MENU button
- Scroll to the right until you see SETUP
- Scroll down and look for RESET
- Press right button so you could see YES or NO
- Select YES
- Press MENU button
- Turn off camera for a few seconds so that
settings will be refreshed

* If it still does not work, call the Manufacturer so they
could tell you how to send camera for repair.