I left my 2GB charging, and when I looked at it, the screen was frozen, I took out the charger, it went black, and now I can't turn it on

My Pandigital screen is frozen, all I get is a green android with a triangle with an explanation mark inside it. How do I reset this?

This is WORKED FOR ME!--->I turned off my computer than unplugged cable and took out battery, held down power button for 1-2mins and than put everything back in (battery and charger) and tried to start it...the screen was still black. I than turned it off again, than pressed ESC, while holding down ESC I pressed and held power button until it briefly turned on and back off. Than I let go of both the buttons and pressed power back on and VOILA the screen came back on. Make sure your charger isn't loose, and than you're aren't surging too much power through the outlets-sometimes these can make the screen black too.
Hope this helps others out there, I have an old Toshiba Satellite running on Windows Vista

I recently had this same problem. The remote displayed a "low battery" warning and could not be used, so I left it on the charger overnight and the next morning, it still had no charge. Everything seemed to be fine (and I verified that it was making good contact with the charger), but it wouldn't charge.

Finally, I pulled out the battery to see if there was any obvious problem. There didn't seem to be, but when I put the battery back in, the remote suddenly started working (and showed about a 75% charge).

So far, it seems to be working (and charging) correctly since then.

go to the main menu click on setting then click onsystem then click onlanguage then click english and mine freezes on me also what ill do is try to cut it off then i put it on the charger then ill go to sleep wake up the next morning and itll be off and unable to turn back on so i plug it up then it starts charging(it only does that to me when the battery is low)and if you turn it back on the screen is gonna pop up with the computer and the plug and it's gonna stay frozen until you plug it up to charge so you change the language and charge it basically.. your welcome i hope my solution helps

reinstall cell software again.

The problem is with the battery, DC will not fully charge the battery to its required capicty to work. You need an AC charger and to charge it fully ( 10 hrs Max) and then try it. It needs a lot of power to drive the screen and connect to satellites.
Invest in an AC charger and all should work properly

Try hitting the reset button. Its the small one on the left side. You might have to push it with a pen or something,

What model is it?
There should a reset pin hole

I just took the battery out and then put it back in.
hehehehe

i would suggest to reset it by pressing the reset button with a toothpick.......i experienced the same problem sometimes,but in your case, my brother who also has one,left it frozen and it went dead after a couple of mins. we connected it to the charger then it worked........i hope it will work on you case.

[email protected]