D-link router DKT-710 Wireless G ADSL2+ starter kit

Means you have no internet connection. Try a new LAN cable between you router and internet modem. Connect directly to you internet modem make certain it is working. Reboot both devices.

The final solution is a factory reset of your router. You can do a factory reset by logging into the router using you browser. Go to the settings and perform a factory reset

If you forgot the router password, you ill have to do a factory reset by locating a small hold on the back of the router and insert the tip of of paper clip for about 10 seconds while the power is on. The router will be reset to out of box status and then you can set-up form scratch.

while connected with a wire surf using internet explorer into the routers console its either at 192.168.0.1 or 192.168.1.1 (most of the time anyway) , Enter the username and pass to get in, often both are admin or admin and blank. check the wireless tab settings in there to see if its enabled and configured.

Always check your LAN cable between your modem and the router and try a new cable. Login the make certain your router is configured correctly to connect to your mode.

Have you tried configuring your wireless settings? If your internet works hard wired, its just the wireless settings that need to be configured. Access the router's setup by going to http://192.168.0.1 and change the wireless channel. Make sure to check the wireless security as well and verify if you are using the correct wireless network key

hi

firstly check to see if the wireless is set for wireless access based on MAC address filtering

also check to see if both the laptop and the wifi router are communicating on the same channel

one question did you have any network hub to connect multiple lan?

Unplug both devices,and remove the cable/dsl line input to modem, wait 5 minutes, plug cable back it, then turn on modem, wait a minute, then plug in router.The signals should mesh.If not, buy a new router, theyre cheap!~

go to your mom and ask if they know how to fixed that problem that you have ,, tc hahaha

The Internet/WAN port on the router should be connected to your cable modem's internet port.
Then on your laptop, you should click on "View available wirless networks", your Router should show up there. click connect and you should be able to surf.
Note::The USB DWA 111 should be connected to your laptop and the drivers installed

Please remember to rate all users who assist you for free :)




I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

don't go for the cd you configure your self abd it think that your dsl not get the perfect dsl link