Autofry error message A05 what does it meen - Kitchen Appliances - Others

A05 code is over heat error, unit has to be cleaned thoroughly. take unit apart and clean, I use a rag,brush,vacuum and compressed air. .
press the helpful button and check links below on disassembles.

Comfortzone CZinfrared removing cabinet how to

Comfortzone CZinfrared panel removal How to

Comfortzone CZinfrared bulb replacement How to

A05 overheat condition, you must clean thoroughly,
press the helpful button

A05-303 Master disposal error - clean master trash bin and check to see if sensor lever in master disposal path is pushed back

First thing to check would be your circuit. Fryers take a lot of amperage. I am guessing you need at least a 20 amp circuit for this fryer and if you are running it on a 15 amp circuit it is going to pop all of the time.

we have a MTI-5 Autofry, and the display shows "Basket Can't Find Home". what can you recomend?

The error code that you have received is from the Temperature Circuit. Please call the MTI/Autofry Technical Support team @ 1-800-348-2976 ext.112 and they will help resolve your issue.

Thank you,
MTI/Autofry

Hi,
"Error A05 - Pressure switch has not been reset "

This is centered around the filter and drain area not working properly.
It is possible it just needs the filter cleaning and the hose flushing out, but also possible the pump needs to come out to clean it properly.
Drain it by putting the hose low down, and clean the filters of debris.
If this does not fix it, then remove the unit outside, lie on it's back and remove the pump to clean it.

the thing might be down to an old master stuck to the drum this could cause the faint copies and the missing print.. pull the drum out check under the master.this would also cause the paper to jam on exit. the error is for no master eject check the calmp is free where it grips the master and also the path for the master eject to the waste bin

Indesit Error Messages and Error Codes Indesit Dishwashers

• F10 - Fill or empty time out. Check that the hoses are not kinked, that the taps are on or whether the drain pump or hose is blocked.
• F11 - Heater timed out. The heater has not reached the required level. Book a service engineer.
• F20 - Temperature under range. Book a service engineer. .
• F21 - Temperature over range. Book a service engineer.

Fault codes for Indesit LCD Dishwasher Models

• A01 - Float switch operated - Book a service engineer.
• A02 - Open/Short circuit heater relay - Book a service engineer.
• A03 - Short circuit on thermistor - Book a service engineer.
• A04 - Unable to reach or sense temperature within 70 minutes - Book service engineer.
• A05 - Pressure switch has not been reset - Book a service engineer.
• A07 - Open/Short circuit wash motor triac - Book a service engineer.
• A08 - Open/Short circuit auxiliary wash motor triac - Book a service engineer.
• A09 - Open/Short circuit with main wash traic - Book a service engineer.
• A10 - Open/Short circuit fill valve traic - Book a service engineer.
• A11 - Half load valve traic or alternating motor action - Book a service engineer.
• A12 - Open circuit heater rely - Book a service engineer.
• A13 - Open/Short circuit dispenser traic - Book a service engineer.
• A14 - Drain hose too low causing syphoning. Check drain hose and re-adjust.
• H20 - Check tap and pressure of incoming water.

_uacct = "UA-1207243-4";urchinTracker();

A05 - Pressure switch has not been reset - Book a service engineer.