Question about Frigidaire 30" Self-Cleaning Freestanding Electric Range - White-on-White
The "F13" error code means "Bad EEPROM identification/Checksum error".
If reseting the power did not help then according to Frigidaire suggested corrective action the electronic oven control (aka EOC) has to be replaced.
- The part number for the EOC is AP3874704
Posted on Feb 19, 2010
Something wrong here, i found this part for two drastically different prices and it he part number shows two different items for that part number-please clarify. is the electric oven control part the same as a clock timer part?
Posted on Jul 09, 2010
Control's internal memory may have
1- Press Cancel key.
2- If fault returns disconnect power, wait 30 seconds and
3- If the problem persists upon power-up replace the display
If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
Posted on Sep 26, 2009
Tips for a great answer:
Hello friend, thank you for your post!
Based off the information you have provided your question is under an "F13" error code but you also stated that it is showing you an "F1" error. I have researched both error codes for you. "F13" usually indicates error identification, which could be an issue within your control board. "F1" typically can indicate that the range has detected an issue with the runaway temperature (overheating). Both codes could be corrected with a reset, which you can do by flipping the household circuit breaker for roughly ten minutes. If that does not correct the issue I would recommend contacting a professional. I hope this is helpful. -Matt
Usually answered in minutes!
Step 2: Please assign your manual to a product: