My kyocera km 1500, it says "add toner" and when replaced by a new toner the "add toner" still reads and an E33 also appears. it doesnt start. what does it mean?pls help me fix it

Replace the toner, open and close the front door several times and let it cycle until the E33 disappears. Comes from copying even after add toner display comes on.

From what I remember on this copier...... The software in the copier may be from another country.... OP or AP most likely the copier needs a new toner installed or could be a paper jam in the doc feeder. The codes were a bit messed up between different countries, I did not biuld them.... Good Luck

try to put direct toner in the developing unit then restart the machine if problem still persist try to replaced your developer

C 710 is a Toner Sensor Problem

Defective toner sensor - Replace toner sensor

Poor contact of the toner sensor connector terminals - Reinsert the connector. Also check for continuity within the connector cable. If none, repair or replace cable.

Developer problem - Replace developer.

E 33 means that the machine is out of toner. Please replace toner the machine will be ok.

Hi 
The AP message indicates thet the dev is so low in toner that the machine has to go into a full cycle mode to get the toner levels up.
The error code is telling you that one cycle is not enough. you will have to turn the copier off/on and cycle it at least one more time....more if neccessary

cs 1500

it is support cnon np 1215 toner
first time
you clean copier toner unite clean complite previous toner then put canon np 1215 toner print ok

If its on the rear side of the page would most likely to be the transfer unit. What model is the machine?

Thanks Jason

Reset what? The imaging unit or the toner cartridge? Replace with a new one or get a recharged one.