We had our oven in the garage for 20 hrs while we replaced the flooring. Now the oven doesn't work just the range. Why?

Clock & Main control display issues - YouTube

? 4:44
https://www.youtube.com/watch?v=OmOocInxHOo
Jun 28, 2013 - Uploaded by ApplianceVideo.com
... symptoms: Clock and display does not work At: http://www.appliancevideo.com For ... and show you how to ...

Range/Stove/Oven Repair - Replacing the Clock Timer ...

? 3:42
https://www.youtube.com/watch?v=0RSnf4wfSZM
Oct 20, 2011 - Uploaded by PartSelect
Range/Stove/Oven Repair - Replacing the Clock Timer (Frigidaire Part .... My timer still works fine, but ...

Y0315570 Amana Range/Stove/Oven - Appliance Timer

it seems to be very expensive shop arround there are alot of con men out there and he seems to be one a control pannel for that oven $105 and easy to fix no time at all $195 to fit 20 mins work at most 30mins

Hello,

Remove the oven floor & the access panel below the door,inside of lower access panel their will a gas valve with a red button on it, push red button,light pilot burner connected to main oven burner,hold red button for 15-20 seconds,release red button and pilot should be on.reinstall panels

If you release red button and pilot goes out the thermocoupler needs to be replaced

Good luck
I hope this helps,if it does please give me a 4 thumbs up rating

Gene

With the oven door open, watch the vents at the sides of the floor of the chamber for an orange glow a few seconds after you try to turn the oven on. If it doesn't appear and is similar to other later ranges, it means the igniter has failed. If built as others, it will have hot-surface igniters (one down, one up) and the lower one has failed.
To confirm that this does use the common system, air out the oven first then try the broiler. If it works, you have gas available but nothing to ignite it. Also, you should never get even a distinct thump; this could be dangerous and the gas should not flow without lighting for more than a few seconds.

pull out the racks and remove the bottom floor of the oven,turn it on bake,if the ignitor doesn't glow most likely it's bad,if it does glow and it doesn't ignite within 40 to 60 seconds the ignitor is bad.even though it glows doesn't mean it's good,it works by amps.it takes 3.2 amps.for a flat ignitor to open the gas valve and 2.5 amps for a round ignitor to open the gas valve.

Hello,

Unplug the oven if it still doesn't work the erc will need to be replaced.

http://www.appliancerepairlesson.com/

Quiet possibly, but make sure there are leveling legs installed and the front edge of the range is not blocked by any flooring. It may be that the oven is not receiving enough combustion air. (sometimes happens when flooring is replaced and legs are removed so the range is not higher than the countertop, or a layer of flooring is added to the room and buts up against the range, where flooring was not added.)

Hi,
The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating
http://www.fixya.com/support/r3663023-oven_not_working_or_oven_not_heating

heatman101

Hi,

The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating

Oven Problems Replacing the Igniter


heatman101


hgdhgd

The glow plug underneath the over floor need to be replaced