No 6V power via power adapter to Sony ICF-SW7600GR

replace the drive I.C

check the connection inside the radio, switch of AC-DC connector maybe loose contact.( leak diode more probability replace it)

Hello
I've send the manual you asked by gmail. Go to your mail and download it. OK.

Try this , they sell power adapters for sony CD radio cassettehttp://www.powerpayless.com/6v-ac-dc-power-adapter-for-sony-icf-w55-icfw55-multi-band-radio.html

www.universal-radio.com

Hello Xiar, Yes the center pin is positive. You have to use any regulated 6volt DC adapter.It may be a good ideea to put a 6v regulator (xx7806) after the adaptor bridge. I have a icf7600 fm/mw/sw 7band receiver too and I`m looking for the service manual or the pcb layout for it. If it by chance you have it mail me at [email protected] Regard, Alex

A transformer type (Linear Mode Power Supply) AC to DC power adapter with a 9.V nominal output, measures about 12.V without load when tested with a multimeter. A power adapter with a nominal output of 7.5 V, measures a little over 9.V. Considering a number of people across different forums reported the adapter's measured power output as 12.V, I think the nominal rating of the AC to DC adapter should be 9.V. However, keep away from Switch Mode Power Supplies.

Click Sony Support to download instruction manual (PDF file) of ICF-SW7600GR

hi, you resolv you problem of the icf-c1ip ?what is DC volts ?

Thanks ;)