Front Loader Washer Door Hinge broken

Replacing the door hinge on a Bosch WAT286H0GB washing machine can be a bit tricky. Here are some general steps that can help you put the front and back panels of the door back together:

1. Make sure that all the parts are in the correct place and that the door hinge is properly aligned.
2. Place the back panel of the door onto the front panel, lining up the hinge with the corresponding holes on the back panel.
3. Insert the hinge pins into the holes on the back panel and ensure they are securely in place.
4. Secure the panels together by tightening the screws.
5. Check that the door is operating correctly and that there is no wobbling or loose feeling when you open and close it.

It is always important to refer to the manufacturer's manual for specific instructions on how to fix the door hinge on your Bosch WAT286H0GB washing machine. If you are still having trouble, it might be a good idea to seek the help of a professional repairman.

Link to PART:

Bosch Washer Hinge - AppliancePartsPros.com
http://www.appliancepartspros.com/bosch-washer-hinge.html

Link to VIDEO - "HOW TO REPLACE DOOR HINGE"
(scroll down half way at this link)
VIDEO: Washing Machine Door Hinge ' eSpares
http://www.espares.co.uk/product/es486275/washing-machine-door-hinge

http://www.appliancepartspros.com/bosch-washer-parts.html

Hello - Contact the manufacturer to see if they have any updated or alternate door hinges that you can install yourself. The weight of some front loader doors, and how they are closed/slammed, can wear over time.

Go to YouTube find how to open your washer. There is a parts diagram inside with all parts and part numbers listed.

You need to replace the door. Here is a link to the part you will need.

To change the seal the easiest way is to take the front of the appliance off. Remove the kick plate at bottom and you will see some screws holding the front panel on remove these Then open door and remove the screws holding the door lock on and unlip the seal by releasing the clamp on the front. The front should now lift off, if it doesnt then pull out the soap drawer and behind that at the bottom of the drawer is a screw holding the front on remove this then push the front panel down then it will lift off You can now take the clamp holding the seal to the tub off. Fit the new seal, fit the clamp to the seal and tub. From here, rebuilding is the reverse of the strip down.

The door hinge block has fallen inside the front of the washer.To retieve it, tilt the washer back, and you should find it at the left hand side.
Remove all screws securing 2 parts of door together, prise apart with a screwdriver or similar, and the door will come apart.
You can now access the hinge and all other partsd inside the door.
Trust this helps.
Thankyou.

There are 4 screws in the door that hold a plastic hinge cover on
.The door will then set into the hinge just fine (PLENTY OF ROOM) and then you put the hinge cover back on and screw the screws in to hold the door onto the hinge.You will likely need a 2nd set of hands to keep from breaking the door.

Even if you do not realise it most people lean on the door as they open it, to rectify with the door open but almost in the closed position lift the door by pulling up on the door catch end, this will straiten the hinge, very common problem Regards Engineer