Our Fisher and Paykel 603 smart drive has stopped

What is the model number of your machine?

Check the out of balance switch (under the larger Grey board)
for corrosion on the terminals and replace if faulty.

Hi just read your posting.Why do you think the machine needs to be reset?Is the machine working?Please reply with additional information and I am sure I can help you.Looking forward to your reply.

i need to know which lights are lit up

this sounds like a computer error asthe first and last lights is an error code 129 which does not exist if its the first and second to last light then its a sensor fault

Hi just read you posting.Could you please confirm the fault code for me.1st push and hold the WASH TEMPERATURE DOWN button then press the POWER button until the machine gives you 2 short beeps,then release both buttons.Now press the SPIN UP or DOWN button until the HOLD and SLOW SPIN LEDs are both on.Now the fault code will appear in the WASH PROGRESS lights.Please reply to confirm which lights are lit.Are they the same as your 1st posting?To get back to normal operation turn machine off at the power point.Looking forward to your reply.

Check the drain pump, it may be overheating and cutting out.

prss and hold the fav button till u hear 2 beeps , set whatever u want it to be and then prss and hold the button till u hear 1 beep turn power off , set

OK Problem located (without Diagnostics) , the problem was a faulty START/PAUSE button. I took the display board apart and fiddled with the button (whilst the power was UNPLUGGED) Starts almost every time, when it does`nt fiddle some more.

while under the lid there should be a tech sheet, explaining varions flashing light codes and there respective fixes for each instance, replacing tha switch(out of bal switch) seems like a good start though. cant remember if jumping it out will help, might be looking for a break in the line rather than continuity through it