Bobcat DI-524 Status light does not come on.

got D-Link - TechSupport FAQ

The wireless Router has not booted up properly. Please Power off and Power on ONCE again.

call you'r cable people

reset you router on factory set and then you can see the satus of lights.

- Updating the firmware of your router will do to fix the issue.

after when i open the browser and open the administrative page what should i do






/

Hello.

The status light is blinking in all dlink models, so that is normal.

The wireless radio issues have 3 possible solutions.

1. This model has a antenna that screws in the bnc socket behind it see if it's well screwed, or substitute it by another if 2 and 3 don't fix it.


2. On the advaced settings of the wireless configuration you have the ratio of radio broadcast from 25% to 100% check to see if it's on 100%, change channel to 11 if neer and 6 if far, make sure you have SSID broadcast enabled.


3. This models allow you to restart the AP unit and the router unit idependently, so it's always good pratice to restart your AP in the tools and system comands menu.


Hope that helps.

Did this happen after a firmware upgrade? If so, this link may help:

http://borgetech.blogspot.com/2007/09/d-link-di-524-revision-b4-status-light.html

Apparently there's a utility which will force firmware to load on the router. The steps are a bit technical, though.

If that doesn't work, the router is probably toast. Time for a new one.

upgrade the firmware

If those lights are lit, they often have a "Code" this code is in the manual. Please find below a link for the manual I am sure all will be found in it. ftp://ftp.dlink.co.uk/di_broadband_gateways/di-524/di-524_manual.pdf Oh & I am sure ya can connect another WiFi'ed PC no prob's.