High reading on everyone using aDinamap GE Pro Care 300

If you have the Home Pro Professional Garment Steamer PS-300 from Homedics, the Homedics website has the manual on their support page. Go to http://www.homedics.com.ph/instructionbooks/ .
then use the drop down menu to select the PS-300. Click on Download to get the instruction book. Note: the file is a PDF, so you will need Adobe Reader or a similar program to read the manual.

I hope this helps.

Cindy Wells

Hello, Two of my pro 300 V2 monitor display "Pnet nibp: module in fatal state (21015400)". Is it a programmed failure? What solution for the remeters in function? Thanking you in advance F. Bonnnin [email protected]

Hello, this is Ava with Think Crucial.

You may find the User's Manual for your Shark model by clicking the link below.

Euro Pro SHARK SV745 Use And Care Instructions

You can purchase a wide variety of high quality Shark replacement parts for your Shark vacuum direct from Think Crucial with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

https://www.thinkcrucial.com/collections/vendors?q=Shark

I hope this was helpful.

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

Jasco products takes care of GE consumer electronics.
Windows 95, 98, 2000, & XP:
http://www.jascoproducts.com/support/software-downloads.asp#pccams

Windows 7:http://www.jascoproducts.com/support/software-downloads-win7.asp

Hello, this is Ava with Think Crucial.

You may find the User's Manual for your GE model by clicking the link below.

GE DDE7109V Use And Care Manual

You can purchase a wide variety of high quality appliances replacement parts direct from Think Crucial with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

https://www.thinkcrucial.com/collections/appliances

I hope this was helpful.

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

Clean and working correctly are 2 different things.
Unplug the range. Remove the temp sensor. Use a meter set for ohms and read 1050 to 1150 ohms at room temperature.
If it reads OK replace the electronic control. If it reads bad replace the temp sensor.

You can try to download it from here http://www.amd.com/uk/Pages/AMDHomePage.aspx
You just need to put in the right windows version on the space on the right side.

IF you just need the latest driver see this link:
http://jascoproducts.com/support/software-downloads.asp#pccams
If you need more support after that just make another comment on this posting
Take Care,
-WN

For those interested in Vista see the following

From GE

http://www.jascoproducts.com/support/vista-certified-products.asp

This may provide additional information -- read this even if the message is not applicable -- it also contains information about non supported camera versions.

When I try to load the driver for GE PC Camera on my Vista operating system, it gives me the following message: Do you want to search for a driver?

Your problem sounds like it could be a vertical sweep fault. Sounds like a vertical output IC or a capcitor in the sweep power supply or a waveshaper capacitor. All these faults, should only be checked and replaced by a pro tech, as there is a safety issue involved with the High voltage, and your going to need to know how to use the equipment to check these parts as in this case , you most likly wont be able to look and see whats wrong or what part is defective. Good Luck