It has kind of like blurry lines going accross the screen?

Check the site linked below, and compare the screen shots. It has many kind of defective screen-shots to plasma displays. Compare them to that of yours, and make sure about the faulty board or others. http://electronicshelponline.blogspot.com/

your screen was broken, change screen with new one

sony lcd blury when we view satelite its common samsung and panasonic give good pitchure then sony bravia tey some good monster cable it will give good pitchure

Hi there some how your camera LCD pressed by out side & the screen is damages. That's why you get the lines. Specially its come some particular area in the LCD screen. Just the way of resolve is resolve the LCD screen. Thanks & waiting for your feedback.

Do you have speakers next to your tv sometimes the line on your tv will be from your sound to close to your tv also the red line could mean your tv tube is going out there about 300 to replace but i ould check frist on your sound are something close to you tv that is maken the red line in the middle of your tv

When this kind of set comes in for this problem, it is typically caused by a leaky/intermittent diode D402, located next to the heat sink for the vertical deflection IC. I will typically also replace the vertical deflection IC at the same time, just to avoid repeat failures.

Bad or loose wire. does this happen only with tv or with dvd and video game too.. check too see if it is every unit then problem is either tv itself or wire connection

If possible, try your monitor with another PC; this sounds more like a video processor problem than a monitor unless you are using it in the VGA-analog mode, then, you could have a bad video cable. The smear can be caused by improper termination and that can come from a failed ground or shield.
Generally speaking, the kind of effect you describe can't happen with a digital interface; they cause the coarse pixelation one sometimes sees on TV sets too.

Perhaps you are using flash in bright areas, make sure that the ring around the "TAKE PICTURE" button is parallel to the ON/OFF button and not on SCN

hi gud day! your problem has a solution. Just try to fix your tv from blurry picture. Pull the socket at hte back of the picture tube. remove the socket from pcb(printed circuit board) de solder the pins. then after that, if you see a 2 metal formed like a small mountain facing each other, try to clean those remove the rust (green color) using sander or any material you can use, just avoid using oil on that bcause it is sparking. then try to install it again and try to turn on your tv. if still not working replace that socket with a new one. you can buy it at any electronic supply store. and re install then on it again.. surely it will fix your tv without expensive components.

be sure unplugging the tv from ac souce before disassimbling...

thanks,
janex