Question about Whirlpool 30" Self-Cleaning Freestanding Electric Range - White-on-White
Whirlpool oven gets ''feature not available'' message when ever a bake, convect is pushed
That happened to my fairly new Whirlpool double oven. But I remembeedr the power in the neighborhood had flickered earlier in the day. So I went to the circuit breaker and shutoff power to the oven for about 30 seconds and turned back on. Everything normal now. I just assumed the slight flicker in the power affected to programming.
Posted on Nov 06, 2013
Thank you!! It worked.
I was able to reset the breaker and that fixed the problem!
×
SOURCE: oven won't heat after self cleaning
There is a overload thermostat located on the rear of your oven that needs to be replaced.
Self cleaning operations are not recommended by this technician.
Posted on Mar 02, 2009
SOURCE: I inadvertently locked my oven.. How do I get it
here is a link that could probably help you its differrent model but the mecanism is the same.Kindly click the link below to find out:
http://applianceguru.com/forum1/611.html
If you find my answer helpful,please vote.Cheers and God Bless
Posted on Nov 10, 2009
SOURCE: Whirlpool double oven has a loud fan when baking
There will be some noise from the fan, but it should not be excessive, if it is really loud, then this is an indication that the fan is failing, and should be replaced ASAP.
Posted on Mar 12, 2010
SOURCE: GE Profile -Installed wall oven - won't heat
brand new??? under a year old??? if so you have a warr call for service, but it sounds like an ignitor isssue, brand new , perhapsgot damaged in shipping 1-800-ge-cares
Posted on Mar 30, 2008
SOURCE: Double oven / convection not working
It is likely that the convection element is burned out and needs to be replaced. If all other functions are working then this is the place to start. Teh back panel inside of the oven can be removed by removing the 4 visible philips screws on it. The element should look smooth and round, if not then it needs to be replaced. Be sure to turn power off to the oven before replacing it. Remove the screws that fasten the element to the back wall and gently pull the element away from the wall an inch or so. the wires will be exposed and can be unclipped from the element do not let them fall inside of the back of the oven or you will have to remove the oven from the wall to get at the back panel. Install the new element in the reverse procedure. If the element looks good then it will have to be tested with a multimeter to verify that it is still good before proceeding to check the selector switch for burn marks.
Posted on Mar 11, 2007
26,490 views
Usually answered in minutes!
Had the same problem with an oven/microwave combo. The microwave worked fine but the oven gave the 'feature not available' message when pushing 'bake'. Tried the power reset several times, didn't help. Had to replace the control panel board. $287.
×