Maytag ensignia electric dryer makes alot if

Sounds like the thermostat has gone out. www.repairclinic.com has helped me so much in the past. Have the model number ready and look at the troubleshooting questions. Good luck.

Hello Jodi Roberts. I want to help you with your problem but I will need a little more information please.

Can you describe the noise? Is it a vibrating type noise or Is it a squealing sound, as though the belt is slipping? Can you smell something from the dryer similar to the smell of burning rubber?

Dependent upon what you describe can tell me if it is the rollers or glides in the front of the drum support; OR rollers or bearings in the rear of the drum.

Or as I said before, a slipping belt from either a seized bearing on the drive pulley, or the idler tension pulley, or simply a worn & frayed belt that just needs to be replaced due normal wear & tear.

Thank-you.

pu *** on timed dry instead of regular. This happened to me the other day and I don't know why :(

When i put clothers in my dryer it does not move and it make a sound when i push the start buttom

Hope this dosent seem to simple ,but have you tried changing the fuse in plug?

Try Googling " user manual for Maytag Ensignia MDE4658AYW ". You may have to go to the Maytag web site and ask for manual. Sometimes I've had to ask for repair manual instead of user manual. Good luck.

if its electric burning smell,its either a overheating motor,capacitor or both or burnt connections,sounds like a motor problem,it will be very hot to touch if its failing,check capacitor though as it could be causing motor to overheat,rating of cap is on side

It sounds like your belt needs to be replaced. You're smelling the melting (burning) rubber.

I also had a similar problem with my maytag dryer which is 3 1/2 years old. It was the idler lever assembly with pulley. The part number is 11222607JG and the cost is about $20.00. Hope this helps.

How old is this dryer? If it is older that 15 years get a new one. You don't want to deal with the headaches. The motor may be going bad on it and the wiring could be melting. I assume it is not working now. Have him check the breakers. Make sure the connections are o.k. in the back. Clean out the lint piping and look for lint underneath it as well.