K7MNF-64 NVIDIA nForce2 Socket A Motherboard all I need is a drwoing of the conections /power/reset HD led ....

"I have checked ram and every thing else" (sic) When you say everything else, I presume you mean with No HD, No DVD, NO "Other" cards in slots, No USB, & just a monitor connected? If yes to all those, then yes I would think that the MB has developed a Fault. The "Red Light" this LED usually signals that the MB is receiving good power, it is NOT a "Fault Light". have you REPLACED the RAM with new ones? You say "Alarm" what exactly is this alarm sound?

3.0vdc-3.5 vdc battery number CR2032

Supports up to 2 GB RAM 266/333/400 (aka: PC2100/PC2700/PC3200)

i only see support xp for this chipset

xp video driver NVIDIA® GeForce®4™ MX graphics
64MB DDR if not work then use AGP slot with

supported
AGP Slot: Support AGP V3.0 32bit / 66MHz 4X/8X card

k7mnf-64 manual

Try this link from another forum: http://www.elhvb.com/mboards/oem/emachines/manuals/K7MNF-64_manual.zip

Install the nForce 2 motherboard drivers. The onboard network controller drivers are part of the package.

That means that ur CPU is shot. That means ur CPU is no good.

Power is not going to the board. Check the power supply cables going to the board; most use a big 20 pin connector & a 2nd 4 pin connector. Make sure both are plugged into the proper spots then retry boot. Should see a green light on motherboard if power is properly set up. Hope this helps.

i need to know were the power sw and the p led +, and the p led -, and the hdd led , and the reset sw go on the mother board go

I did just solve all my problems with my own FIC K7MNF-64

Stop error: 0x0000007b / may be caused by attempting to load XP HOME

I've not determined exactly why attempting to load XP Home will cause
error 0x0000007b on the FIC K7MNF-64 , but it does , and it's a situaion not covered in the microsoft artical on it.

From what I can gather XP pro was the offical operating sytem for the board which I've now loaded to mine , windows 98/ME can load to it without problem so that rules out a hardware issue on my end.

eMachine T3395 or W3050 shipped with the FIC K7MNF-64 in them.

Drivers can still be obtained from eMachine for the board as of 8-26-2008
but for XP pro only from what I can see. you may need to hunt around for
98/ME drivers , even if you manage to get 98/ME drivers you will most likely still have a PCI Universal Serial Bus issue so best to load XP pro if possible.


I hope this information saves some people alot of time.

May the nForce2 be with you , always.