Question about Excalibur. K9-MUNDIAL-SS Entry Level Auto Alarm with Dual Zone Shock Sensor

1 Answer

How do I disconnect the alarm system

I just want to disconnect it how do I disconnect the alram system

Posted by lil_baller_1 on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 50 Answers

AN EASIER WAY TO DISARM THE ALARM IS TO FIND A SWITCH MOUNTED USUALLY UNDER STEERING COLUMN OR DRIVERS KICK PANEL.

JUST TURN KEY ON
THEN FLIP THE SWITCH.
IF ITS A PUSH BUTTON THEN JUST HOLD DOWN FOR SEVERAL SECONDS AFTER YOU TURN THE KEY ON.

REMOVING THE BRAIN IS EASY.
LAY ON YOUR BACK ON DRIVERS FLOOR AND REMOVE ANY PANELING IF IN THE WAY AND FIND SMALL BLACK BOX ABOUT 4" X 4" X 1.5" MOUNTED WITH ZIP TIES. JUST UNPLUG AND TAPE OFF THE PLUG.

Posted on Jan 23, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fuse for disarming alram system


There isn't one the alarm if factory fitted is integrated into the ecm so to disable the alarm you would need to disable the engine control module

Jan 25, 2017 | Cars & Trucks

2 Answers

I have a UND. MSG. alarm on my Galaxy 5000


Did you get an answer for this question?

Apr 08, 2014 | APC Computers & Internet

1 Answer

Alram system


great question...
stock or aftermarket.
btw, stock means as left factory..... not hacked.

Oct 19, 2013 | 1996 Jeep Grand Cherokee

1 Answer

1993 Camry V6 Your Question has been posted toyota camry 1993 4 cylinder, hazard lights flash some times when starting car, and stayon for a few minutes also side indicator light is stuck on had to...


This could be caused by a malfunctioning aftermarket alarm system, check to see if there is a small LED on a bracket on the lower left of the dash, if it has this I would recommend having the system removed at an automotive alram shop.

Oct 02, 2011 | 1993 Toyota Camry V6

1 Answer

Can i by bypass my car alram


The car alarm on your 2000 Windstar minivan is wired into your van's battery. When you are making a repair to your car such as a battery change out your alarm can go off. You can easily disable the Windstar's car alarm by disconnecting the battery from the alarm. The battery is connected to the Windstar battery's negative terminal. Disconnecting the terminal from the battery will disable the alarm.

  • Socket wrench
  1. 1 Raise the hood of the Windstar to gain access to the battery.
  2. 2 Loosen the negative battery terminal labeled with a "-" with a socket wrench.
  3. 3 Disconnect the terminal from the battery to disable the alarm system.



Dec 12, 2010 | 1999 Ford Windstar

1 Answer

Unhook postive cable lights flashing will not


Sometimes the alarm gets tripped when the battery has been disconnected as the system thinks someone is trying to steal the vehicle when it loses power. Usually if you reconnect the battery [and the alarm sounds] then lock and unlock the drivers door with the key or the remote on the key fob it will reset the alarm and everything will work again. I've had to try a couple of times to get these systems to reset so you may have to do the same. There may also be a procedure listed in your owners manual for this situation so I'd take a look there too. Good luck, hope this helps out!

Jul 28, 2010 | 1999 Chevrolet Tahoe

1 Answer

I ignored the alarm in my 2004 Saturn when it went off. From that point on I cannot use my remote to open the trunk,have to use the key. Is it the alarm system or replacing a fuse?


It maybe both. If the alarm is built into the ECM you can try disconnecting the Negetive battery terminal to reset the ECM. Make sure all the fuses are good for the alarm and for the trunk release. If the alram is not incorporated in the ECM remove the in-line fuse from the power line of the alarm to reset the alarm. This should resolve the problem if the problem is the alarm and not the release.

Nov 15, 2009 | 2004 Saturn ION

1 Answer

Our alarm has just started going off when we unlock the drivers side door.. how do we disconnect it..1995 jeep grand cherokee. we know about locking and unlocking the door but lately it hasnt been...


when the alarm goes off try unlocking the trunk the jeep i bought the larm is runned through the trunk if i dont unlock the trunk first the alram goes off

Oct 31, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Battery dead


You need to hook the alarm back up and do a reset on the car.

Here is how you do it.

1) Turn factory original key to "ON" position for 5 seconds
2) Turn key to "OFF" position.
3) Repeat 1 and 2 again. Do it twice.
4) This should reset the computer to the chip inside the key.

If that didn't work,You will need to have the codes downloaded at the dealer.

Aug 08, 2009 | 1995 Nissan Maxima

Not finding what you are looking for?
Excalibur. K9-MUNDIAL-SS Entry Level Auto Alarm with Dual Zone Shock Sensor Logo

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dual Electronics Vehicle Parts & Accessories Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Brad Brown

Level 3 Expert

18520 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Are you a Dual Electronics Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...