Our microwave suddenly stopped operating.

The signs are not always evident, but from the description the magnetron has failed.

Hi,

Here is a tip that will help you to figure out what is wrong with your Microwave Oven....

Basic Microwave Oven Troubleshooting Tips

heatman101

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101
fgshg

you will get any Hinari manual with the manualfox search engine. Check results here:
http://manualfox.com/link/hinari.htm

a few possible causes,
1, the high voltage fuse,
2, the high voltage capacitor
3, the slow blow fuse ( normally found on a small pcb inside unit)

other than that, check the door switches and maybe the x former.
good luck.

E-02 on the LED display.

That usually indicates a keyboard error...not a good thing...take it back and get a new one.

My parents had the same problem. It turned out that a switch went bad. When you take the case off, there are 3 switches where the door latches. The bottom switch went bad. It is an Omron D3V-16G-3C25 switch.

need a solution

Sounds like a bad connection inside. unplug the power, take off the cover, look over all the connectors closely.

Generally, the most common causes of a failure to heat are:

- bad door switches or door switch mounts
- loose connection at the magnetron
- problem or loose connection on the control unit circuit board
- bad magnetron or other high voltage part such as high-voltage rectifier diode

If you or a friend decide to look into it, we have critical safety information, info on door switch diagnosis and
replacement, and disassembly information at our site, linked here on Fixya: http://tinyurl.com/yzjozk