Down loading pictures

no car told at all just year. cuts off?? means what?. we can not see car or drive it.
the engine stalls, 0 RPM driving? automatic transmission?
or engine misfires. (shakes hard felt and heard)
or engine bogs (means lack of engine power)smooth loss?

or all electrics go dead for sure head lamps driving,
radio goes dead
heater blower goes dead.
modern cars can have 30+ fuses and 50 +loads
Imagine a tree? and learn those paths.
and we learn to see if car has electrical problems first.
no car told so I give up
ok fast right foot can not save the stall. a free test

or engine runs great just dash fails.
I cannot figure it out.

Some of the Pantograms software programs require a USB dongle connected to the computer. However, the driver for this dongle has to be installed before you install the software or connect the dongle. I suspect you may not have installed the driver or the dongle is missing.

Assuming that the dongle is connected:
Close your embroidery software program and all of the Pantograms software, including the Network C software, on your computer and remove the USB device. Put the software install CD into your machine's optical drive. (If your new machine doesn't have an optical drive, get a USB optical drive or copy the files from the CD to a 1GB+ USB flash drive at another computer with an optical drive.) If Windows XP starts the autorun routine for the CD, click Exit. Then double-left click on My Computer to launch File Explorer. Go to the CD drive (or USB drive if you used the work-around) and double-click on it. Open the Rainbow Drivers folder and then open the XP folder. Double click on the program: setup.exe . Choose Complete install as the program executes. Then close File Explorer when the install is done. Now insert the USB dongle and follow the on-screen message about New Hardware found to install the Rainbow driver from C: .

If you do not see the New Hardware found message, try putting the dongle into a different USB port. (Make sure to avoid USB hubs - they can add to USB device issues.) If the dongle doesn't work at any port, you may need to use a different method. There is a flash reader available for connecting a USB flash drive to the Toyota 830 here: http://www.plrelectronics.com/lab/usb_reader.php . (Scroll down to the Toyota machine section. This isn't cheap but it is cheaper than some of the newer embroidery software packages.)

I hope this helps.

Cindy Wells

First check whether your USB driver properly installed or not.if not then install it,

Tyne and Wear Data Recovery
Data Recovery Tyne and Wear

push piston back in.it may have a ridge build up.if so ,lightly scrape or sand it down.---bingo

You TV cannot use a wifi wireless dongle. The usb port on your tv is for connecting a usb drive for pictures or movies. There is no place to load the drivers necessary for a wifi or bluetooth dongle.

Hello Please see the image below for correct jumper setting
Hope this helps, if so do rate the solution

U NEED TO FORMAT IT 1ST INSERT THE FLASH DRIVE GO TO MY COMPUTER GO TO THAT DRIVE IT MYT B NAMED AS STORAGE (E) OR (F) DAN RIGHT CLICK ON IT SCROLL DOWN TO PROPERTIES CHOOSE FORMAT AND SELECT QUICK FORMAT. HOPE THIS IS HELPFULLY. :)

Hello,
for connecting the dongle open the cap
connect to the USB port u had infront or back
wait for some time for recognisation the dongle stick
after finishing ur work do not plug it out
select the stick and right click on it
select the "Safely remove"
wait for some time till u get message as "Its safe to remove"
then only un-plug the stick

Let me know if your problem is solved and rate me as FIXYA!

you cant unlock sprint phones. Called them and they said its impossible because they have their sim cards built right in to their phones so the only thing you can do is have them transferred to another persons sprint account. its bulls***