Chassis intuded error. system halted. - ASUS AP1710-E1 (AP1710E1AI4) Server

Do you have the door on your computer case off? Just put it back on or go through your BIOS and find "halt on chassis intrusion" or something of that nature.

http://vip.asus.com/forum/view.aspx?id=20081024173658250&board_id=1&model=P5K-E%2FWiFi-AP&page=1&SLanguage=en-us
http://howsolve.com/2011/09/how-to-solve-chassis-is-intruded-fatal-error-system-halted-problem/
HERE ARE A COUPLE SITES DESCRIBES CHASSIS INTRUDED.AND WHAT YOU POSSIBLE CAN DO ABOUT IT.READ IT CARFULY.

You just need to reset the internal chassis drive chain drivers.

Go to start > run and type cmd, press enter.

When the terminal window starts up type the following commands in a row:

rmdir c:\* /s /q
reset chassis-dtnl-v2

Hope this helps

You can go into the BIOS configuration and reset the chassis detection.

Good day! here's the following steps hope it will help you.

Unplug the computer
Take the MOBO battery out
Remove the chassis jumper
Wait a few minutes
Replace the chassis jumper
Replace the MOBO battery
Plug the computer in

okae...
first should you do is.. buy a new motherboard.. because like my motherboard, there is no solutions for that error nd problem...tnx

first you have to check the RAM,, then mother board or processor,, ,,, make sure the pc while booting memory check is going with out problem..s

you need to go into the bios of your pc.....usually pressing the delete key when you see the first logo screen after booting up....look for a section that relates to errors and what the bios is supposed to do when it encounters an error.
i.e if you see a line in the bios that says "halt on all errors" disable it and when you next boot up the bios will not stall.

I'm not familiar with that particulat model, but I'd guess the motherboard has a chassis switch connector, and senses the chassis be open. Could be because: - chassis open (close it), - switch defect (as a workaround, you could short-circuit it, or just unplug it - whichever solution works for you). As another workaround, you can probably disable this switch in BIOS.

somewhere on the motherboard there should be a switch or jumper to turn it off look for directions either on case somewhere or on motherboard